Water hardness in Chalco, NE
Water in Chalco is very hard, with a median of 260 mg/L (15.2 grains per gallon) across 41 monitoring sites within 10 miles.
Chalco tap water at a glance
- HardnessVery hard (260 mg/L, 15.2 gpg, local measurements). Water softeners are common at this level.Size a water softener →
Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?
What 260 mg/L means at home
- Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
- Dishwasher: set the water hardness to about 15.2 gpg (14.6 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
- Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
- Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
- Water heater: flush the tank once a year to clear sediment and scale.
Size a softener for your home → Hard water and your water heater →
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Chalco
Prefilled with Chalco's measured local hardness of 260 mg/L (15.2 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
PFAS in Chalco tap water
Chalco is served by more than one water system. These systems supply ZIP codes in Chalco and were tested for PFAS ("forever chemicals") in EPA's nationwide UCMR 5 study. Check your water bill to see which one is yours.
Water systems serving Chalco
| Water system | PFAS detected | Highest PFOA / PFOS | Tested |
|---|---|---|---|
| Metropolitan Utilities District serves over 10,000 people | None detected | — | Nov 2024 – Aug 2025 |
What these PFAS levels mean → Which water filters remove PFAS →
Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology
Lead pipes in Chalco
Chalco is served by more than one water system. Their service line inventories, as reported to EPA:
Water systems serving Chalco
| Water system | Service lines | Total |
|---|---|---|
| Metropolitan Utilities District | 11,738 lead · 333 galvanized · 2,505 unknown | 232,322 |
How to tell if your home has a lead pipe → Lead pipes in every state →
As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology
Chalco drinking water violations
Chalco is served by more than one water system. Health-based violations recorded by EPA since 2016:
Water systems serving Chalco
| Water system | Health-based violations | Monitoring/reporting |
|---|---|---|
| Metropolitan Utilities District | None | 1 |
Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology
Monitoring sites closest to Chalco
| Site | Type | Distance | Median | Samples | Years |
|---|---|---|---|---|---|
| WEHLKND1 U.S. Army Corps of Engineers Omaha District | Reservoir | 1.1 mi | 122 mg/L | 11 | 2006–2020 |
| EZRLKND1 U.S. Army Corps of Engineers Omaha District | Reservoir | 2.9 mi | 128 mg/L | 12 | 2006–2020 |
| QACNELAKEFBK U.S. Army Corps of Engineers Omaha District | Reservoir | 3.1 mi | 0 mg/L | 7 | 2010–2020 |
| QACNELAKEDUP U.S. Army Corps of Engineers Omaha District | Reservoir | 3.1 mi | 131 mg/L | 11 | 2010–2020 |
| EZRLKUP1 U.S. Army Corps of Engineers Omaha District | Reservoir | 3.5 mi | 122 mg/L | 11 | 2006–2020 |
| WCRLKND1 U.S. Army Corps of Engineers Omaha District | Reservoir | 4.4 mi | 122 mg/L | 11 | 2006–2017 |
Water hardness in towns near Chalco
| Town | Distance | Median | Class |
|---|---|---|---|
| La Vista | 3 mi | 260 mg/L | Very hard |
| Papillion | 4 mi | 259 mg/L | Very hard |
| Omaha | 7 mi | 286 mg/L | Very hard |
| Bellevue | 12 mi | 310 mg/L | Very hard |
| Fremont | 25 mi | 211 mg/L | Very hard |
| Lincoln | 38 mi | 248 mg/L | Very hard |
| Columbus | 66 mi | 322 mg/L | Very hard |
| Beatrice | 70 mi | 57 mg/L | Soft |
| Norfolk | 89 mi | 237 mg/L | Very hard |
| South Sioux City | 90 mi | 431 mg/L | Very hard |
Sarpy County
Chalco is in Sarpy County, where the median is 259 mg/L (very hard) across 57 sites.
See all of Sarpy County →Hardness scale
What to read next
- Do you need a water softener?Water here is very hard; size a softener with our calculator.
- Hard water and your water heaterHow scale affects your water heater and how often to flush.
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.