Water hardness in Stillwater, MN
Water in Stillwater is moderately hard, with a median of 102 mg/L (6 grains per gallon) across 47 monitoring sites within 10 miles.
Stillwater tap water at a glance
- HardnessModerately hard (102 mg/L, 6 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
- PFAS5 found; the highest PFOS and PFOA result was above EPA's 4 ppt limit (a single result is not a violation).Filters that remove PFAS →
- Lead pipesNo lead service lines reported.Details →
- ViolationsNo health-based violations since 2016.EPA record →
Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?
What 102 mg/L means at home
- Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
- Dishwasher: set the water hardness to about 6 gpg (5.7 °dH), which is a low-to-medium hardness setting.
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Stillwater
Prefilled with Stillwater's measured local hardness of 102 mg/L (6 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
PFAS in Stillwater tap water
The City of Stillwater water system is the main public water system for Stillwater. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 15 samples taken Dec 2024 – Jun 2025. 5 PFAS were detected. The highest PFOS and PFOA results were above EPA's drinking water limit (4 ppt).
| Chemical | Highest result | Detected in | EPA limit |
|---|---|---|---|
| PFBA perfluorobutanoic acid | 118 ppt | 15 of 15 samples | — |
| PFOS perfluorooctane sulfonic acid | 8.1 ppt | 3 of 15 samples | 4 ppt |
| PFHxS perfluorohexane sulfonic acid | 7.2 ppt | 3 of 15 samples | 10 ppt* |
| PFOA perfluorooctanoic acid | 5.2 ppt | 3 of 15 samples | 4 ppt |
| PFPeA perfluoropentanoic acid | 4.5 ppt | 6 of 15 samples | — |
Other water systems serving parts of Stillwater
| Water system | PFAS detected | Highest PFOA / PFOS | Tested |
|---|---|---|---|
| Oak Park Heights serves 10,000 people or fewer | PFBA, PFHxS, PFBS +2 more | — | May 2023 – Nov 2023 |
What these PFAS levels mean → Which water filters remove PFAS →
Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology
Lead pipes in Stillwater
The City of Stillwater water system reported 6,649 service lines (the pipes connecting homes to the water main) in its inventory. 0 are lead and 799 are galvanized lines that must be replaced.
EPA's 2024 lead rule requires most water systems to replace these lines within 10 years, starting in November 2027 (the rule is being challenged in court). Ask the City of Stillwater water system whether your address is on its list.
Other water systems serving parts of Stillwater
| Water system | Service lines | Total |
|---|---|---|
| Oak Park Heights | 0 lead · 0 galvanized · 0 unknown | 1,450 |
How to tell if your home has a lead pipe → Lead pipes in every state →
As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology
Stillwater drinking water violations
EPA records show no health-based violations for the City of Stillwater water system since 2016. It also had 2 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.
Other water systems serving parts of Stillwater
| Water system | Health-based violations | Monitoring/reporting |
|---|---|---|
| Oak Park Heights | None | 0 |
Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology
Monitoring sites closest to Stillwater
| Site | Type | Distance | Median | Samples | Years |
|---|---|---|---|---|---|
| UNN STR, OUTLET FROM MCKUSICK WETLAND, S OF MCKUSICK RD, IN STILLWATER, MN Minnesota Pollution Control Agency - Ambient Surface Water (State) | River/Stream Perennial | 0.8 mi | 151 mg/L | 29 | 2022–2025 |
| LILY Minnesota Pollution Control Agency - Ambient Surface Water (State) | Lake | 0.9 mi | 38 mg/L | 16 | 2010–2013 |
| UNN STR (BROWN'S CK) AT MCKUSICK RD IN STILLWATER Minnesota Pollution Control Agency - Ambient Surface Water (State) | River/Stream | 0.9 mi | 153 mg/L | 21 | 2022–2025 |
| 030N20W32BCABDA01 Stillwater 0000224608 USGS Minnesota Water Science Center | Well | 0.9 mi | 244 mg/L | 1 | 2014 |
| UNN STR (TRIB TO MCKUSICK LK) AT THE BROWN'S CK DIVERSION Minnesota Pollution Control Agency - Ambient Surface Water (State) | River/Stream | 1.1 mi | 146 mg/L | 52 | 2022–2025 |
| BROWNS CK AT STONEBRIDGE TR NO IN STILLWATER Minnesota Pollution Control Agency - Ambient Surface Water (State) | River/Stream | 1.2 mi | 140 mg/L | 18 | 2022–2025 |
Water hardness in towns near Stillwater
| Town | Distance | Median | Class |
|---|---|---|---|
| Lake Elmo | 6 mi | 140 mg/L | Hard |
| Oakdale | 8 mi | 134 mg/L | Hard |
| White Bear Lake | 9 mi | 132 mg/L | Hard |
| North St. Paul | 9 mi | 133 mg/L | Hard |
| Hugo | 10 mi | 133 mg/L | Hard |
| Maplewood | 10 mi | 134 mg/L | Hard |
| Woodbury | 11 mi | 236 mg/L | Very hard |
| Vadnais Heights | 12 mi | 125 mg/L | Hard |
| Little Canada | 13 mi | 145 mg/L | Hard |
| Forest Lake | 15 mi | 136 mg/L | Hard |
Washington County
Stillwater is in Washington County, where the median is 137 mg/L (hard) across 54 sites.
See all of Washington County →Stillwater, MN water: common questions
Do I need a water softener in Stillwater?
Probably not. Water measured around Stillwater is 6 gpg (102 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable. If spotting bothers you, about 11,000 grains of capacity covers a 3-person home between weekly regenerations.Size it for your household →
Who supplies Stillwater's drinking water?
The main public water system serving Stillwater in EPA records is Stillwater. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →
Do I need a water filter in Stillwater?
It depends on what you want to remove. In Stillwater, EPA testing found PFBA, PFOS and PFHxS and 2 other PFAS in the main system; filters certified to NSF/ANSI 53 or 58 for PFOA and PFOS reduction can lower PFAS. On the other hand, no lead service lines reported and no health-based violations since 2016. A water softener is not a filter.Filters that remove PFAS →
Hardness scale
What to read next
- Which water filters remove PFAS?EPA tests found 5 PFAS in Stillwater's main water system.
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.