Water hardness in Ham Lake, MN
Water in Ham Lake is very hard, with a median of 284 mg/L (16.6 grains per gallon) across 15 monitoring sites within 10 miles.
Ham Lake tap water at a glance
- HardnessVery hard (284 mg/L, 16.6 gpg, local measurements). Water softeners are common at this level.Size a water softener →
Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?
What 284 mg/L means at home
- Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
- Dishwasher: set the water hardness to about 16.6 gpg (15.9 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
- Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
- Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
- Water heater: flush the tank once a year to clear sediment and scale.
Size a softener for your home → Hard water and your water heater →
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Ham Lake
Prefilled with Ham Lake's measured local hardness of 284 mg/L (16.6 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
PFAS in Ham Lake tap water
Ham Lake is served by more than one water system. These systems supply ZIP codes in Ham Lake and were tested for PFAS ("forever chemicals") in EPA's nationwide UCMR 5 study. Check your water bill to see which one is yours.
Water systems serving Ham Lake
| Water system | PFAS detected | Highest PFOA / PFOS | Tested |
|---|---|---|---|
| Andover serves over 10,000 people | PFBA | — | May 2024 – Nov 2024 |
What these PFAS levels mean → Which water filters remove PFAS →
Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology
Lead pipes in Ham Lake
Ham Lake is served by more than one water system. Their service line inventories, as reported to EPA:
Water systems serving Ham Lake
| Water system | Service lines | Total |
|---|---|---|
| Andover | 0 lead · 0 galvanized · 0 unknown | 7,196 |
How to tell if your home has a lead pipe → Lead pipes in every state →
As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology
Ham Lake drinking water violations
Ham Lake is served by more than one water system. Health-based violations recorded by EPA since 2016:
Water systems serving Ham Lake
| Water system | Health-based violations | Monitoring/reporting |
|---|---|---|
| Andover | None | 0 |
Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology
Monitoring sites closest to Ham Lake
| Site | Type | Distance | Median | Samples | Years |
|---|---|---|---|---|---|
| CR-J 031N24W01DCCD 01 0000685846 USGS Minnesota Water Science Center | Well | 5.5 mi | 138 mg/L | 2 | 2006–2016 |
| CR-B 031N24W03ACC 01 0000560396 USGS Minnesota Water Science Center | Well | 6.7 mi | 340 mg/L | 2 | 2006–2016 |
| CR-I 031N24W10DAD 01 0000560406 USGS Minnesota Water Science Center | Well | 7.1 mi | 324 mg/L | 2 | 2006–2016 |
| CR-D 031N24W11CCD 01 0000560399 USGS Minnesota Water Science Center | Well | 7.3 mi | 448 mg/L | 2 | 2006–2016 |
| CR-A 032N24W33BDC 01 0000560381 USGS Minnesota Water Science Center | Well | 7.5 mi | 220 mg/L | 8 | 2000–2016 |
| CR-H 031N24W04BAB 01 0000560405 USGS Minnesota Water Science Center | Well | 7.6 mi | 330 mg/L | 2 | 2006–2016 |
Water hardness in towns near Ham Lake
| Town | Distance | Median | Class |
|---|---|---|---|
| Blaine | 6 mi | 235 mg/L | Very hard |
| Andover | 7 mi | 272 mg/L | Very hard |
| East Bethel | 7 mi | 148 mg/L | Hard |
| Coon Rapids | 8 mi | 338 mg/L | Very hard |
| Lino Lakes | 8 mi | 128 mg/L | Hard |
| Anoka | 10 mi | 334 mg/L | Very hard |
| Mounds View | 10 mi | 198 mg/L | Very hard |
| Champlin | 11 mi | 344 mg/L | Very hard |
| Forest Lake | 11 mi | 136 mg/L | Hard |
| Shoreview | 12 mi | 166 mg/L | Hard |
Anoka County
Ham Lake is in Anoka County, where the median is 235 mg/L (very hard) across 23 sites.
See all of Anoka County →Hardness scale
What to read next
- Do you need a water softener?Water here is very hard; size a softener with our calculator.
- Hard water and your water heaterHow scale affects your water heater and how often to flush.
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.