Water hardness in Fraser, MI

Water in Fraser is very hard, with a median of 216 mg/L (12.6 grains per gallon) across 4 monitoring sites within 10 miles.

44% harder than the Michigan median (150 mg/L) 66th hardest of 101 Michigan towns Population 14,434
216mg/L
12.6 grains per gallon
Very hard

Fraser tap water at a glance

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 216 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 12.6 gpg (12.1 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites4
Lab samples445
Sample years2000–2023
Middle 50% of sites180–254 mg/L
Surface water (rivers, lakes)216 mg/L · 4 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Fraser

Prefilled with Fraser's measured local hardness of 216 mg/L (12.6 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Fraser tap water

City of Fraser is the main public water system for Fraser. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 4 samples taken Nov 2023 – Aug 2024. No PFAS were found at or above EPA's minimum reporting levels.

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Fraser

City of Fraser reported 5,362 service lines (the pipes connecting homes to the water main) in its inventory. It reported no known lead lines, but 159 lines are still of unknown material.

0lead (0%)
0galvanized requiring replacement
159unknown material (3%)
5,203not lead (97%)

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Fraser drinking water violations

EPA records show no health-based violations for City of Fraser since 2016. It also had 8 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Fraser

SiteTypeDistanceMedianSamplesYears
RED RUN AT 14 MILE ROAD AT WARREN, MI
USGS Michigan Water Science Center
Stream 3 mi183 mg/L32005–2006
CLINTON RIVER AT MORAVIAN DRIVE AT MT. CLEMENS, MI
USGS Michigan Water Science Center
Stream 4.5 mi170 mg/L162011–2014
CLINTON RIVER AT GRATIOT AVENUE AT MT. CLEMENS, MI
USGS Michigan Water Science Center
Stream 4.5 mi250 mg/L1622000–2013
CLINTON RIVER AT STERLING HEIGHTS, MI
USGS Michigan Water Science Center
Stream 6.7 mi268 mg/L2642001–2023

Water hardness in towns near Fraser

TownDistanceMedianClass
Roseville2 mi 216 mg/LVery hard
St. Clair Shores4 mi 183 mg/LVery hard
Eastpointe5 mi 526 mg/LVery hard
Warren5 mi 105 mg/LModerately hard
Sterling Heights5 mi 268 mg/LVery hard
Mount Clemens5 mi 250 mg/LVery hard
Harper Woods7 mi 766 mg/LVery hard
Grosse Pointe Woods7 mi 766 mg/LVery hard
Madison Heights8 mi 304 mg/LVery hard
Hazel Park9 mi 526 mg/LVery hard

Macomb County

Fraser is in Macomb County, where the median is 282 mg/L (very hard) across 16 sites.

See all of Macomb County →

Michigan

The statewide median is 150 mg/L (hard) from 1,435 sites.

Michigan hardness map →

Fraser, MI water: common questions

Do I need a water softener in Fraser?

Very likely. Water measured around Fraser is 12.6 gpg (216 mg/L, measured locally), above 10.5 gpg (180 mg/L), where softeners are common. For a 3-person home that regenerates weekly, that means a softener of about 22,000 grains.Size it for your household →

Who supplies Fraser's drinking water?

The main public water system serving Fraser in EPA records is City of Fraser. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Fraser?

Not for anything in EPA's records: no PFAS found in EPA testing, no lead service lines reported and no health-based violations since 2016. People here who use a filter usually do it for taste, such as chlorine.Chlorine taste in tap water →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next