Water hardness in Seabrook, MD
Water in Seabrook is moderately hard, with a median of 60 mg/L (3.5 grains per gallon) across 19 monitoring sites within 10 miles.
Seabrook tap water at a glance
- HardnessModerately hard (60 mg/L, 3.5 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?
What 60 mg/L means at home
- Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
- Dishwasher: set the water hardness to about 3.5 gpg (3.4 °dH), which is a low-to-medium hardness setting.
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Seabrook
Prefilled with Seabrook's measured local hardness of 60 mg/L (3.5 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
PFAS in Seabrook tap water
Seabrook is served by more than one water system. These systems supply ZIP codes in Seabrook and were tested for PFAS ("forever chemicals") in EPA's nationwide UCMR 5 study. Check your water bill to see which one is yours.
Water systems serving Seabrook
| Water system | PFAS detected | Highest PFOA / PFOS | Tested |
|---|---|---|---|
| Washington Suburban Sanitary Commission serves over 10,000 people | PFPeA, PFHxA | — | Mar 2023 – Jun 2024 |
What these PFAS levels mean → Which water filters remove PFAS →
Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology
Lead pipes in Seabrook
Seabrook is served by more than one water system. Their service line inventories, as reported to EPA:
Water systems serving Seabrook
| Water system | Service lines | Total |
|---|---|---|
| Washington Suburban Sanitary Commission | 8 lead · 1,277 galvanized · 57,121 unknown | 58,406 |
How to tell if your home has a lead pipe → Lead pipes in every state →
As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology
Seabrook drinking water violations
Seabrook is served by more than one water system. Health-based violations recorded by EPA since 2016:
Water systems serving Seabrook
| Water system | Health-based violations | Monitoring/reporting |
|---|---|---|
| Washington Suburban Sanitary Commission | None | 0 |
Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology
Monitoring sites closest to Seabrook
| Site | Type | Distance | Median | Samples | Years |
|---|---|---|---|---|---|
| PG Cd 25 USGS Maryland Water Science Center | Well | 0.9 mi | 5 mg/L | 1 | 2016 |
| BALD MILL BRANCH AT LANHAM, MD USGS Maryland Water Science Center | Stream | 1.8 mi | 103 mg/L | 1 | 2000 |
| HORSEPEN BRANCH AT BOWIE, MD USGS Maryland Water Science Center | Stream | 3.5 mi | 74 mg/L | 1 | 2000 |
| LOTTSFORD BRANCH NEAR GLENARDEN, MD USGS Maryland Water Science Center | Stream | 3.7 mi | 57 mg/L | 1 | 2000 |
| NORTHEAST BRANCH ANACOSTIA RIVER AT RIVERDALE, MD USGS Maryland Water Science Center | Stream | 4.3 mi | 60 mg/L | 1 | 2007 |
| PG Be 38 USGS Maryland Water Science Center | Well | 4.7 mi | 7 mg/L | 1 | 2003 |
Water hardness in towns near Seabrook
| Town | Distance | Median | Class |
|---|---|---|---|
| Lanham | 2 mi | 60 mg/L | Moderately hard |
| New Carrollton | 2 mi | 60 mg/L | Moderately hard |
| Greenbelt | 2 mi | 60 mg/L | Moderately hard |
| Glenn Dale | 3 mi | 53 mg/L | Soft |
| East Riverdale | 4 mi | 67 mg/L | Moderately hard |
| Mitchellville | 4 mi | 67 mg/L | Moderately hard |
| Landover | 4 mi | 60 mg/L | Moderately hard |
| College Park | 5 mi | 103 mg/L | Moderately hard |
| Summerfield | 5 mi | 67 mg/L | Moderately hard |
| Beltsville | 5 mi | 54 mg/L | Soft |
Prince George's County
Seabrook is in Prince George's County, where the median is 60 mg/L (moderately hard) across 27 sites.
See all of Prince George's County →Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.