Water hardness in Maryland City, MD

Water in Maryland City is soft, with a median of 16 mg/L (1 grains per gallon) across 21 monitoring sites within 10 miles.

71% softer than the Maryland median (56 mg/L) 112th hardest of 121 Maryland towns Population 16,093 (2010)
16mg/L
1 grains per gallon
Soft

Maryland City tap water at a glance

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 16 mg/L means at home

  • Water softener: A water softener is generally not needed. Soft water rarely causes scale.
  • Dishwasher: set the water hardness to about 1 gpg (0.9 °dH), which is the lowest hardness setting (or softener off).
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites21
Lab samples23
Sample years2000–2019
Middle 50% of sites12–49 mg/L
Groundwater (wells, springs)16 mg/L · 19 sites
Surface water (rivers, lakes)45 mg/L · 2 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Maryland City

Prefilled with Maryland City's measured local hardness of 16 mg/L (0.9 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Maryland City tap water

Maryland City is served by more than one water system. These systems supply ZIP codes in Maryland City and were tested for PFAS ("forever chemicals") in EPA's nationwide UCMR 5 study. Check your water bill to see which one is yours.

Water systems serving Maryland City

Water systemPFAS detectedHighest PFOA / PFOSTested
Glen Burnie-Broadneck
serves over 10,000 people
None detected — Nov 2024 – May 2025

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Maryland City

Maryland City is served by more than one water system. Their service line inventories, as reported to EPA:

Water systems serving Maryland City

Water systemService linesTotal
Glen Burnie-Broadneck0 lead · 48 galvanized · 8,124 unknown8,172

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Maryland City drinking water violations

Maryland City is served by more than one water system. Health-based violations recorded by EPA since 2016:

Water systems serving Maryland City

Water systemHealth-based violationsMonitoring/reporting
Glen Burnie-BroadneckNone12

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Maryland City

SiteTypeDistanceMedianSamplesYears
AA Bb 90
USGS Maryland Water Science Center
Well 1.9 mi5 mg/L22009–2016
AA Bb 91
USGS Maryland Water Science Center
Well 1.9 mi50 mg/L22009–2016
AA Bb 92
USGS Maryland Water Science Center
Well 2.5 mi39 mg/L12009
AA Bb 88
USGS Maryland Water Science Center
Well 2.5 mi12 mg/L12009
HO Df 60
USGS Maryland Water Science Center
Well 2.9 mi16 mg/L12009
AA Bb 86
USGS Maryland Water Science Center
Well 3.5 mi24 mg/L12009

Water hardness in towns near Maryland City

TownDistanceMedianClass
Laurel3 mi 24 mg/LSoft
South Laurel4 mi 16 mg/LSoft
Severn6 mi 23 mg/LSoft
Odenton6 mi 23 mg/LSoft
Elkridge7 mi 49 mg/LSoft
Columbia7 mi 50 mg/LSoft
Beltsville8 mi 54 mg/LSoft
Fairland8 mi 60 mg/LModerately hard
Glenn Dale8 mi 53 mg/LSoft
Ilchester8 mi 50 mg/LSoft

Anne Arundel County

Maryland City is in Anne Arundel County, where the median is 95 mg/L (moderately hard) across 57 sites.

See all of Anne Arundel County →

Maryland

The statewide median is 56 mg/L (soft) from 1,412 sites.

Maryland hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next