Water hardness in Auburn, ME

Water in Auburn is soft, with a median of 57 mg/L (3.4 grains per gallon) across 6 monitoring sites within 10 miles.

30% harder than the Maine median (44 mg/L) 5th hardest of 12 Maine towns Population 24,793
57mg/L
3.4 grains per gallon
Soft

Auburn tap water at a glance

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 57 mg/L means at home

  • Water softener: A water softener is generally not needed. Soft water rarely causes scale.
  • Dishwasher: set the water hardness to about 3.4 gpg (3.2 °dH), which is the lowest hardness setting (or softener off).
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites6
Lab samples12
Sample years2000–2023
Middle 50% of sites42–65 mg/L
Groundwater (wells, springs)57 mg/L · 6 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Auburn

Prefilled with Auburn's measured local hardness of 57 mg/L (3.3 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Auburn tap water

Auburn Water District is the main public water system for Auburn. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 4 samples taken Sep 2023 – Jul 2024. No PFAS were found at or above EPA's minimum reporting levels.

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Auburn

Auburn Water District reported 6,214 service lines (the pipes connecting homes to the water main) in its inventory. It reported no known lead lines, but 3,373 lines are still of unknown material.

0lead (0%)
0galvanized requiring replacement
3,373unknown material (54%)
2,841not lead (46%)

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Auburn drinking water violations

EPA records show no health-based violations for Auburn Water District since 2016. It also had 1 monitoring or reporting violation (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Auburn

SiteTypeDistanceMedianSamplesYears
ME-ANW1135 Poland, Maine
USGS Maine Water Science Center
Well 5.7 mi60 mg/L52001–2003
ME-ANW1136 HHID 077 HETLID B027283 RECRUITID 114
USGS Maine Water Science Center
Well 6 mi38 mg/L12007
ME-ANW 1132
USGS Maine Water Science Center
Well 6.5 mi87 mg/L22000–2011
ME-ANW 1157
USGS Maine Water Science Center
Well 9 mi38 mg/L22014–2023
ME-CW 2024
USGS Maine Water Science Center
Well 9.1 mi67 mg/L12000
ME-ANW 1130
USGS Maine Water Science Center
Well 9.6 mi54 mg/L12011

Water hardness in towns near Auburn

TownDistanceMedianClass
Lewiston4 mi 60 mg/LModerately hard
Brunswick20 mi 24 mg/LSoft
Westbrook27 mi 41 mg/LSoft
Augusta31 mi 49 mg/LSoft
Portland31 mi 43 mg/LSoft
South Portland31 mi 50 mg/LSoft
Saco39 mi 46 mg/LSoft
Waterville43 mi 68 mg/LModerately hard
Biddeford45 mi 87 mg/LModerately hard
Sanford52 mi 44 mg/LSoft

Androscoggin County

Auburn is in Androscoggin County, where the median is 53 mg/L (soft) across 10 sites.

See all of Androscoggin County →

Maine

The statewide median is 44 mg/L (soft) from 251 sites.

Maine hardness map →

Auburn, ME water: common questions

Do I need a water softener in Auburn?

Probably not. Water measured around Auburn is 3.4 gpg (57 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable.When a softener helps →

Who supplies Auburn's drinking water?

The main public water system serving Auburn in EPA records is Auburn Water District. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Auburn?

Not for anything in EPA's records: no PFAS found in EPA testing, no lead service lines reported and no health-based violations since 2016. People here who use a filter usually do it for taste, such as chlorine.Chlorine taste in tap water →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next