Water hardness in Danville, IN

Water in Danville is very hard, with a median of 309 mg/L (18 grains per gallon) across 6 monitoring sites within 10 miles.

about the same as the Indiana median (303 mg/L) 35th hardest of 86 Indiana towns Population 11,525
309mg/L
18 grains per gallon
Very hard

Danville tap water at a glance

  • HardnessVery hard (309 mg/L, 18 gpg, local measurements). Water softeners are common at this level.Size a water softener →
  • PFAS2 found in EPA testing; every result with a federal limit was at or below it.PFAS results →
  • Lead pipesNo lead service lines reported.Details →
  • ViolationsNo health-based violations since 2016.EPA record →

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 309 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 18 gpg (17.3 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites6
Lab samples18
Sample years2001–2018
Middle 50% of sites300–314 mg/L
Groundwater (wells, springs)330 mg/L · 2 sites
Surface water (rivers, lakes)303 mg/L · 4 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Danville

Prefilled with Danville's measured local hardness of 309 mg/L (18.1 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Danville tap water

Danville Water Works is the main public water system for Danville. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 8 samples taken Apr 2024 – Dec 2025. 2 PFAS were detected.

ChemicalHighest resultDetected inEPA limit
PFPeA
perfluoropentanoic acid
3.8 ppt 3 of 8 samples —
PFHxA
perfluorohexanoic acid
3 ppt 1 of 8 samples —

Other water systems serving parts of Danville

Water systemPFAS detectedHighest PFOA / PFOSTested
Plainfield Water Works
serves over 10,000 people
PFPeA, PFBS, PFHxA — Mar 2025 – Oct 2025
Citizens Water - Indianapolis
serves over 10,000 people
PFPeA, PFBA, PFHxA +1 more — Aug 2023 – Aug 2024

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Danville

Danville Water Works reported 3,304 service lines (the pipes connecting homes to the water main) in its inventory. It reported no lead or galvanized lines requiring replacement.

0lead (0%)
0galvanized requiring replacement
0unknown material (0%)
3,304not lead (100%)

Other water systems serving parts of Danville

Water systemService linesTotal
Plainfield Water Works0 lead · 0 galvanized · 210 unknown11,040
Citizens Water - Indianapolis56,766 lead · 195 galvanized · 39,935 unknown374,679

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Danville drinking water violations

EPA records show no health-based violations for Danville Water Works since 2016. It also had 1 monitoring or reporting violation (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.

Other water systems serving parts of Danville

Water systemHealth-based violationsMonitoring/reporting
Plainfield Water Works12
Citizens Water - IndianapolisNone1

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Danville

SiteTypeDistanceMedianSamplesYears
NAWQA AG WELL TP21 NEAR TILDEN, IN
USGS Indiana Water Science Center
Well 4.2 mi350 mg/L22002–2014
RAMP RUN CREEK NEAR NORTH SALEM, IN
USGS Indiana Water Science Center
Stream 8.4 mi316 mg/L12004
NAWQA AG WELL TP4 AT RAINTOWN, IN
USGS Indiana Water Science Center
Well 8.6 mi310 mg/L22002–2014
WWU150-0012
Indiana STORET
River/Stream 9.4 mi308 mg/L12001
WWU150-0011
Indiana STORET
River/Stream 9.8 mi298 mg/L32001
SCHOOL BRANCH AT NOBLE DRIVE AT BROWNSBURG, IN
USGS Indiana Water Science Center
Stream 9.9 mi268 mg/L92016–2018

Water hardness in towns near Danville

TownDistanceMedianClass
Avon5 mi 193 mg/LVery hard
Brownsburg8 mi 196 mg/LVery hard
Plainfield8 mi 269 mg/LVery hard
Speedway13 mi 196 mg/LVery hard
Whitestown16 mi 231 mg/LVery hard
Zionsville19 mi 292 mg/LVery hard
Indianapolis19 mi 292 mg/LVery hard
Lebanon19 mi 318 mg/LVery hard
Bargersville22 mi 300 mg/LVery hard
Beech Grove22 mi 264 mg/LVery hard

Hendricks County

Danville is in Hendricks County, where the median is 308 mg/L (very hard) across 14 sites.

See all of Hendricks County →

Indiana

The statewide median is 303 mg/L (very hard) from 1,344 sites.

Indiana hardness map →

Danville, IN water: common questions

Do I need a water softener in Danville?

Very likely. Water measured around Danville is 18 gpg (309 mg/L, measured locally), above 10.5 gpg (180 mg/L), where softeners are common. For a 3-person home that regenerates weekly, that means a softener of about 31,000 grains.Size it for your household →

Who supplies Danville's drinking water?

The main public water system serving Danville in EPA records is Danville Water Works. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Danville?

It depends on what you want to remove. In Danville, EPA testing found PFPeA and PFHxA in the main system; filters certified to NSF/ANSI 53 or 58 for PFOA and PFOS reduction can lower PFAS. On the other hand, no lead service lines reported and no health-based violations since 2016. A water softener is not a filter.Filters that remove PFAS →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next