Water hardness in Crown Point, IN
Water in Crown Point is very hard, with a median of 366 mg/L (21.3 grains per gallon) across 14 monitoring sites within 10 miles.
Crown Point tap water at a glance
- HardnessVery hard (366 mg/L, 21.3 gpg, local measurements). Water softeners are common at this level.Size a water softener →
- PFASNone found in EPA's nationwide testing of the main water system.PFAS results →
- Lead pipesThe water system reported 15 lead service lines.Check your own pipe →
- ViolationsNo health-based violations since 2016.EPA record →
Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?
What 366 mg/L means at home
- Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
- Dishwasher: set the water hardness to about 21.3 gpg (20.5 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
- Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
- Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
- Water heater: flush the tank once a year to clear sediment and scale.
Size a softener for your home → Hard water and your water heater →
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Crown Point
Prefilled with Crown Point's measured local hardness of 366 mg/L (21.4 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
PFAS in Crown Point tap water
Crown Point Water Works is the main public water system for Crown Point. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 4 samples taken Mar 2023 – Mar 2024. No PFAS were found at or above EPA's minimum reporting levels.
Other water systems serving parts of Crown Point
| Water system | PFAS detected | Highest PFOA / PFOS | Tested |
|---|---|---|---|
| Indiana American Water - Northwest serves over 10,000 people | None detected | — | Jun 2023 – Mar 2024 |
| ST. John Municipal Water Utility serves over 10,000 people | None detected | — | Mar 2025 – Oct 2025 |
What these PFAS levels mean → Which water filters remove PFAS →
Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology
Lead pipes in Crown Point
Crown Point Water Works reported 14,347 service lines (the pipes connecting homes to the water main) in its inventory. 15 are lead and 184 are galvanized lines that must be replaced, and 2,563 are still of unknown material.
EPA's 2024 lead rule requires most water systems to replace these lines within 10 years, starting in November 2027 (the rule is being challenged in court). Ask Crown Point Water Works whether your address is on its list.
Other water systems serving parts of Crown Point
| Water system | Service lines | Total |
|---|---|---|
| Indiana American Water - Northwest | 10,833 lead · 183 galvanized · 36,484 unknown | 91,302 |
| ST. John Municipal Water Utility | 0 lead · 0 galvanized · 0 unknown | 10,060 |
How to tell if your home has a lead pipe → Lead pipes in every state →
As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology
Crown Point drinking water violations
EPA records show no health-based violations for Crown Point Water Works since 2016. It also had 7 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.
Other water systems serving parts of Crown Point
| Water system | Health-based violations | Monitoring/reporting |
|---|---|---|
| Indiana American Water - Northwest | None | 0 |
| ST. John Municipal Water Utility | None | 0 |
Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology
Monitoring sites closest to Crown Point
| Site | Type | Distance | Median | Samples | Years |
|---|---|---|---|---|---|
| UMK130-0037 Indiana STORET | River/Stream | 4.8 mi | 290 mg/L | 2 | 2004 |
| LMG030-0002 Indiana STORET | River/Stream | 5.2 mi | 110 mg/L | 1 | 2000 |
| UMK130-0014 Indiana STORET | River/Stream | 6.2 mi | 430 mg/L | 1 | 2000 |
| UMK130-0013 Indiana STORET | River/Stream | 6.4 mi | 430 mg/L | 1 | 2000 |
| UMK130-0015 Indiana STORET | River/Stream | 6.5 mi | 460 mg/L | 1 | 2000 |
| UMK130-0011 Indiana STORET | River/Stream | 6.7 mi | 440 mg/L | 1 | 2000 |
Water hardness in towns near Crown Point
| Town | Distance | Median | Class |
|---|---|---|---|
| Merrillville | 5 mi | 316 mg/L | Very hard |
| Cedar Lake | 6 mi | 305 mg/L | Very hard |
| St. John | 7 mi | 360 mg/L | Very hard |
| Schererville | 7 mi | 260 mg/L | Very hard |
| Hobart | 8 mi | 248 mg/L | Very hard |
| Lowell | 9 mi | 334 mg/L | Very hard |
| Griffith | 9 mi | 282 mg/L | Very hard |
| Dyer | 10 mi | 360 mg/L | Very hard |
| Highland | 11 mi | 260 mg/L | Very hard |
| Munster | 13 mi | 232 mg/L | Very hard |
Lake County
Crown Point is in Lake County, where the median is 250 mg/L (very hard) across 91 sites.
See all of Lake County →Crown Point, IN water: common questions
Do I need a water softener in Crown Point?
Very likely. Water measured around Crown Point is 21.3 gpg (366 mg/L, measured locally), above 10.5 gpg (180 mg/L), where softeners are common. For a 3-person home that regenerates weekly, that means a softener of about 37,000 grains.Size it for your household →
Who supplies Crown Point's drinking water?
The main public water system serving Crown Point in EPA records is Crown Point Water Works. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →
Do I need a water filter in Crown Point?
It depends on what you want to remove. In Crown Point, the system reports 15 lead service lines; if your home has one, a filter certified to remove lead is the usual step until the line is replaced. On the other hand, no PFAS found in EPA testing and no health-based violations since 2016. A water softener is not a filter.Check your own service line →
Hardness scale
What to read next
- Do you need a water softener?Water here is very hard; size a softener with our calculator.
- How to tell if your home has a lead pipe15 lead service lines are reported here.
- Hard water and your water heaterHow scale affects your water heater and how often to flush.
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.