Water hardness in Kewanee, IL

Water in Kewanee is very hard, with a median of 355 mg/L (20.7 grains per gallon) across Henry County.

21% harder than the Illinois median (293 mg/L) 33rd hardest of 225 Illinois towns Population 12,222
355mg/L
20.7 grains per gallon
Very hard

There are not enough monitoring sites within 10 miles of Kewanee, so this page uses the Henry County median.

Kewanee tap water at a glance

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 355 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 20.7 gpg (19.9 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites3
Lab samples26
Sample years2000–2018
Middle 50% of sites339–365 mg/L
Groundwater (wells, springs)323 mg/L · 1 sites
Surface water (rivers, lakes)365 mg/L · 2 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Kewanee

Prefilled with Kewanee's measured local hardness of 355 mg/L (20.8 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Kewanee tap water

The City of Kewanee water system is the main public water system for Kewanee. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 4 samples taken Sep 2025 – Mar 2026. No PFAS were found at or above EPA's minimum reporting levels.

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Kewanee

The City of Kewanee water system reported 5,457 service lines (the pipes connecting homes to the water main) in its inventory. 1,230 are lead and 0 are galvanized lines that must be replaced, and 1 are still of unknown material.

1,230lead (23%)
0galvanized requiring replacement
1unknown material (<1%)
4,226not lead (77%)

EPA's 2024 lead rule requires most water systems to replace these lines within 10 years, starting in November 2027 (the rule is being challenged in court). Ask the City of Kewanee water system whether your address is on its list.

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Kewanee drinking water violations

EPA records show no health-based violations for the City of Kewanee water system since 2016. It also had 5 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Kewanee

SiteTypeDistanceMedianSamplesYears
15N 5E- 4.3c1
USGS Illinois Water Science Center
Well 0.9 mi323 mg/L22007–2017
West Fork Spoon River
illinois epa (State)
River/Stream 8.2 mi352 mg/L22000

Water hardness in towns near Kewanee

TownDistanceMedianClass
Galesburg31 mi 314 mg/LVery hard
East Moline31 mi 307 mg/LVery hard
Moline34 mi 307 mg/LVery hard
Peoria37 mi 370 mg/LVery hard
Rock Island38 mi 307 mg/LVery hard
Sterling41 mi 333 mg/LVery hard
East Peoria44 mi 367 mg/LVery hard
Washington45 mi 328 mg/LVery hard
Canton47 mi 320 mg/LVery hard
Dixon48 mi 312 mg/LVery hard

Henry County

Kewanee is in Henry County, where the median is 355 mg/L (very hard) across 3 sites.

See all of Henry County →

Illinois

The statewide median is 293 mg/L (very hard) from 1,100 sites.

Illinois hardness map →

Kewanee, IL water: common questions

Do I need a water softener in Kewanee?

Very likely. Water measured around Kewanee is 20.7 gpg (355 mg/L, measured locally), above 10.5 gpg (180 mg/L), where softeners are common. For a 3-person home that regenerates weekly, that means a softener of about 36,000 grains.Size it for your household →

Who supplies Kewanee's drinking water?

The main public water system serving Kewanee in EPA records is Kewanee. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Kewanee?

It depends on what you want to remove. In Kewanee, the system reports 1,230 lead service lines; if your home has one, a filter certified to remove lead is the usual step until the line is replaced. On the other hand, no PFAS found in EPA testing and no health-based violations since 2016. A water softener is not a filter.Check your own service line →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next