Water hardness in Columbia, IL

Water in Columbia is very hard, with a median of 216 mg/L (12.6 grains per gallon) across Monroe County.

26% softer than the Illinois median (293 mg/L) 210th hardest of 225 Illinois towns Population 10,933
216mg/L
12.6 grains per gallon
Very hard

There are not enough monitoring sites within 10 miles of Columbia, so this page uses the Monroe County median.

Columbia tap water at a glance

  • HardnessVery hard (216 mg/L, 12.6 gpg, local measurements). Water softeners are common at this level.Size a water softener →
  • PFAS2 found in EPA testing; every result with a federal limit was at or below it.PFAS results →
  • ViolationsNo health-based violations since 2016.EPA record →

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 216 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 12.6 gpg (12.1 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites3
Lab samples12
Sample years2000–2004
Middle 50% of sites214–226 mg/L
Surface water (rivers, lakes)216 mg/L · 3 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Columbia

Prefilled with Columbia's measured local hardness of 216 mg/L (12.6 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Columbia tap water

The City of Columbia water system is the main public water system for Columbia. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 4 samples taken Oct 2024 – Jun 2025. 2 PFAS were detected.

ChemicalHighest resultDetected inEPA limit
PFBA
perfluorobutanoic acid
11.5 ppt 4 of 4 samples —
PFBS
perfluorobutane sulfonic acid
3.4 ppt 1 of 4 samples —

Other water systems serving parts of Columbia

Water systemPFAS detectedHighest PFOA / PFOSTested
IL American-East ST Louis
serves over 10,000 people
PFBA, PFHxA, PFPeA — Nov 2023 – Aug 2024

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Columbia

The City of Columbia water system has not yet reported its service line inventory to EPA (as of the first quarter of 2026). Ask the utility whether your home's service line has been identified.

Other water systems serving parts of Columbia

Water systemService linesTotal
IL American-East ST Louis749 lead · 351 galvanized · 34,431 unknown71,163

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Columbia drinking water violations

EPA records show no health-based violations for the City of Columbia water system since 2016. It also had 4 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.

Other water systems serving parts of Columbia

Water systemHealth-based violationsMonitoring/reporting
IL American-East ST LouisNone1

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Columbia

SiteTypeDistanceMedianSamplesYears
Mississippi River
illinois epa (State)
River/Stream 7 mi216 mg/L82000–2002

Water hardness in towns near Columbia

TownDistanceMedianClass
Cahokia Heights9 mi 379 mg/LVery hard
Waterloo9 mi 216 mg/LVery hard
East St. Louis12 mi 386 mg/LVery hard
Belleville13 mi 348 mg/LVery hard
Swansea14 mi 368 mg/LVery hard
Fairview Heights15 mi 363 mg/LVery hard
Shiloh18 mi 348 mg/LVery hard
Collinsville19 mi 416 mg/LVery hard
O'Fallon19 mi 372 mg/LVery hard
Granite City19 mi 398 mg/LVery hard

Monroe County

Columbia is in Monroe County, where the median is 216 mg/L (very hard) across 3 sites.

See all of Monroe County →

Illinois

The statewide median is 293 mg/L (very hard) from 1,100 sites.

Illinois hardness map →

Columbia, IL water: common questions

Do I need a water softener in Columbia?

Very likely. Water measured around Columbia is 12.6 gpg (216 mg/L, measured locally), above 10.5 gpg (180 mg/L), where softeners are common. For a 3-person home that regenerates weekly, that means a softener of about 22,000 grains.Size it for your household →

Who supplies Columbia's drinking water?

The main public water system serving Columbia in EPA records is Columbia. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Columbia?

It depends on what you want to remove. In Columbia, EPA testing found PFBA and PFBS in the main system; filters certified to NSF/ANSI 53 or 58 for PFOA and PFOS reduction can lower PFAS. On the other hand, no health-based violations since 2016. A water softener is not a filter.Filters that remove PFAS →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next