Water hardness in Mill Valley, CA
Water in Mill Valley is moderately hard, with a median of 90 mg/L (5.3 grains per gallon) across 3 monitoring sites within 10 miles.
Mill Valley tap water at a glance
- HardnessModerately hard (90 mg/L, 5.3 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?
What 90 mg/L means at home
- Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
- Dishwasher: set the water hardness to about 5.3 gpg (5 °dH), which is a low-to-medium hardness setting.
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Mill Valley
Prefilled with Mill Valley's measured local hardness of 90 mg/L (5.3 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
PFAS in Mill Valley tap water
Mill Valley is served by more than one water system. These systems supply ZIP codes in Mill Valley and were tested for PFAS ("forever chemicals") in EPA's nationwide UCMR 5 study. Check your water bill to see which one is yours.
Water systems serving Mill Valley
| Water system | PFAS detected | Highest PFOA / PFOS | Tested |
|---|---|---|---|
| Marin Municipal Water District serves over 10,000 people | None detected | — | Jul 2023 – Jul 2024 |
What these PFAS levels mean → Which water filters remove PFAS →
Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology
Lead pipes in Mill Valley
Mill Valley is served by more than one water system. Their service line inventories, as reported to EPA:
Water systems serving Mill Valley
| Water system | Service lines | Total |
|---|---|---|
| Marin Municipal Water District | 0 lead · 0 galvanized · 0 unknown | 63,060 |
How to tell if your home has a lead pipe → Lead pipes in every state →
As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology
Mill Valley drinking water violations
Mill Valley is served by more than one water system. Health-based violations recorded by EPA since 2016:
Water systems serving Mill Valley
| Water system | Health-based violations | Monitoring/reporting |
|---|---|---|
| Marin Municipal Water District | None | 0 |
Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology
Monitoring sites closest to Mill Valley
| Site | Type | Distance | Median | Samples | Years |
|---|---|---|---|---|---|
| REDWOOD C A BIG LAGOON BR NR MUIR BEACH CA USGS California Water Science Center | Stream | 3.5 mi | 90 mg/L | 11 | 2000–2001 |
| CORTE MADERA C A ROSS CA USGS California Water Science Center | Stream | 3.9 mi | 124 mg/L | 6 | 2017 |
| PINE C A BOLINAS CA USGS California Water Science Center | Stream | 8.3 mi | 76 mg/L | 11 | 2000–2001 |
Water hardness in towns near Mill Valley
| Town | Distance | Median | Class |
|---|---|---|---|
| Tamalpais-Homestead Valley | 2 mi | 107 mg/L | Moderately hard |
| Larkspur | 2 mi | 90 mg/L | Moderately hard |
| San Anselmo | 5 mi | 103 mg/L | Moderately hard |
| San Rafael | 5 mi | 124 mg/L | Hard |
| Richmond | 10 mi | 68 mg/L | Moderately hard |
| San Pablo | 12 mi | 421 mg/L | Very hard |
| Novato | 12 mi | 124 mg/L | Hard |
| Albany | 12 mi | 368 mg/L | Very hard |
| El Cerrito | 13 mi | 396 mg/L | Very hard |
| Berkeley | 14 mi | 368 mg/L | Very hard |
Marin County
Mill Valley is in Marin County, where the median is 91 mg/L (moderately hard) across 15 sites.
See all of Marin County →Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.