Water hardness in San Luis, AZ
Water in San Luis is very hard, with a median of 495 mg/L (28.9 grains per gallon) across 12 monitoring sites within 10 miles.
San Luis tap water at a glance
- HardnessVery hard (495 mg/L, 28.9 gpg, local measurements). Water softeners are common at this level.Size a water softener →
- PFASNone found in EPA's nationwide testing of the main water system.PFAS results →
- Lead pipesNo lead service lines reported.Details →
- Violations4 health-based violations since 2016.What they were →
Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?
What 495 mg/L means at home
- Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
- Dishwasher: set the water hardness to about 28.9 gpg (27.7 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
- Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
- Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
- Water heater: flush the tank once a year to clear sediment and scale.
Size a softener for your home → Hard water and your water heater →
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for San Luis
Prefilled with San Luis's measured local hardness of 495 mg/L (28.9 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
PFAS in San Luis tap water
City of San Luis is the main public water system for San Luis. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 12 samples taken Sep 2024 – Aug 2025. No PFAS were found at or above EPA's minimum reporting levels.
Other water systems serving parts of San Luis
| Water system | PFAS detected | Highest PFOA / PFOS | Tested |
|---|---|---|---|
| City of Somerton serves over 10,000 people | None detected | — | Sep 2023 – Feb 2024 |
What these PFAS levels mean → Which water filters remove PFAS →
Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology
Lead pipes in San Luis
City of San Luis reported 8,952 service lines (the pipes connecting homes to the water main) in its inventory. It reported no lead or galvanized lines requiring replacement.
Other water systems serving parts of San Luis
| Water system | Service lines | Total |
|---|---|---|
| City of Somerton | 0 lead · 0 galvanized · 0 unknown | 3,624 |
How to tell if your home has a lead pipe → Lead pipes in every state →
As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology
San Luis drinking water violations
EPA records show 4 health-based violations for City of San Luis since 2016, 1 still open. The most recent began in Apr 2026. It also had 11 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.
| Contaminant or rule | Type | Violations | Most recent | Status |
|---|---|---|---|---|
| Coliform bacteria / E. coli (Revised Total Coliform Rule) bacteria that signal possible contamination of the system · what it means | Treatment requirement not met | 1 | Sep 2021 | 1 open |
| Total trihalomethanes (TTHM) byproducts formed when chlorine reacts with natural matter in water · what it means highest measured 0.088 MG/L; limit 0.080 mg/L | Contaminant above legal limit | 1 | Apr 2026 | Resolved/closed |
| Groundwater Rule requirements to protect well water from fecal contamination | Treatment requirement not met | 2 | Jun 2024 | Resolved/closed |
Other water systems serving parts of San Luis
| Water system | Health-based violations | Monitoring/reporting |
|---|---|---|
| City of Somerton | None | 18 |
Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology
Monitoring sites closest to San Luis
| Site | Type | Distance | Median | Samples | Years |
|---|---|---|---|---|---|
| 242 LATERAL ABOVE MAIN DRAIN AT AZ-SONORA BOUNDRY USGS Arizona Water Science Center | Stream | 3.8 mi | 437 mg/L | 85 | 2017–2023 |
| YUMA MAIN DRAIN ABOVE ARIZONA-SONORA BOUNDARY USGS Arizona Water Science Center | Stream | 4 mi | 453 mg/L | 90 | 2017–2023 |
| YUMA MW #10 Arizona Department of Environmental Quality | Well | 4 mi | 790 mg/L | 1 | 2001 |
| 56268 AZDEQ_GW | Well | 4 mi | 670 mg/L | 1 | 2001 |
| YUMA MW #9 Arizona Department of Environmental Quality | Well | 5.9 mi | 330 mg/L | 1 | 2001 |
| 56269 AZDEQ_GW | Well | 5.9 mi | 240 mg/L | 1 | 2001 |
Water hardness in towns near San Luis
| Town | Distance | Median | Class |
|---|---|---|---|
| Somerton | 8 mi | 453 mg/L | Very hard |
| Yuma | 12 mi | 345 mg/L | Very hard |
| Fortuna Foothills | 22 mi | 520 mg/L | Very hard |
| Buckeye | 137 mi | 685 mg/L | Very hard |
| Lake Havasu City | 141 mi | 305 mg/L | Very hard |
| Goodyear | 147 mi | 550 mg/L | Very hard |
| Avondale | 150 mi | 465 mg/L | Very hard |
| Surprise | 155 mi | 124 mg/L | Hard |
| El Mirage | 158 mi | 111 mg/L | Moderately hard |
| Sun City West | 160 mi | 95 mg/L | Moderately hard |
Yuma County
San Luis is in Yuma County, where the median is 438 mg/L (very hard) across 154 sites.
See all of Yuma County →San Luis, AZ water: common questions
Do I need a water softener in San Luis?
Very likely. Water measured around San Luis is 28.9 gpg (495 mg/L, measured locally), above 10.5 gpg (180 mg/L), where softeners are common. For a 3-person home that regenerates weekly, that means a softener of about 50,000 grains.Size it for your household →
Who supplies San Luis's drinking water?
The main public water system serving San Luis in EPA records is City of San Luis. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →
Do I need a water filter in San Luis?
It depends on what you want to remove. In San Luis, the system had 4 health-based violations since 2016, for the Revised Total Coliform Rule and TTHM and more; the utility's annual report says what was done about them. On the other hand, no PFAS found in EPA testing and no lead service lines reported. A water softener is not a filter.How to read your water quality report →
Hardness scale
What to read next
- Do you need a water softener?Water here is very hard; size a softener with our calculator.
- TTHM in drinking waterDisinfection byproducts appear in this system's violation record.
- Hard water and your water heaterHow scale affects your water heater and how often to flush.
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.