Water hardness in Polk County, WI
Water in Polk County is moderately hard, with a median of 84 mg/L (4.9 grains per gallon) across 27 monitoring sites.
Polk County water at a glance
- HardnessModerately hard (84 mg/L, 4.9 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 84 mg/L means at home
- Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
- Dishwasher: set the water hardness to about 4.9 gpg (4.7 °dH), which is a low-to-medium hardness setting.
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Polk County
Prefilled with Polk County's measured local hardness of 84 mg/L (4.9 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Polk County on the Wisconsin map
Cities and communities in Polk County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Amery | 18 | Soft | 4 sites within 10 miles |
| Osceola | 86 | Moderately hard | 14 sites within 10 miles |
| St. Croix Falls | 84 | Moderately hard | 10 sites within 10 miles |
| Frederic | 84 | Moderately hard | county median |
| Clear Lake | 172 | Hard | 3 sites within 10 miles |
| Luck | 98 | Moderately hard | 3 sites within 10 miles |
| Milltown | 65 | Moderately hard | 6 sites within 10 miles |
| Dresser | 84 | Moderately hard | 11 sites within 10 miles |
| Balsam Lake | 67 | Moderately hard | 6 sites within 10 miles |
| Centuria | 84 | Moderately hard | 11 sites within 10 miles |
| Clayton | 166 | Hard | 4 sites within 10 miles |
| Lewis (CDP) | 84 | Moderately hard | county median |
Water quality in Polk County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Amery | Amery Waterworks | Not tested | 0 lead · 287 unknown | 1 (1 open) |
| Osceola | Osceola Waterworks | Not tested | 0 lead · 230 unknown | 1 |
| St. Croix Falls | ST Croix Falls Waterworks | Not tested | 0 lead · 321 unknown | None |
| Frederic | Frederic Waterworks | Not tested | 0 lead · 345 unknown | None |
| Clear Lake | Clear Lake Waterworks | Not tested | 0 lead · 0 unknown | None |
| Luck | Luck Waterworks | Not tested | 0 lead · 92 unknown | None |
| Milltown | Milltown Waterworks | Not tested | 0 lead · 0 unknown | None |
| Dresser | Dresser Waterworks | Not tested | 0 lead · 67 unknown | None |
| Balsam Lake | Balsam Lake Waterworks | Not tested | 0 lead · 0 unknown | None |
| Centuria | Centuria Waterworks | Not tested | 0 lead · 0 unknown | None |
| Clayton | Clayton Waterworks | Not tested | 0 lead · 53 unknown | 1 |
Neighboring counties
- Burnett County63 mg/L
- Barron County28 mg/L
- St. Croix County166 mg/L
- Washburn County68 mg/L
- Dunn County111 mg/L
- Pierce County260 mg/L
Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.