Water hardness in Custer County, SD
Water in Custer County is very hard, with a median of 233 mg/L (13.6 grains per gallon) across 65 monitoring sites.
Custer County water at a glance
- HardnessVery hard (233 mg/L, 13.6 gpg, local measurements). Water softeners are common at this level.Size a water softener →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 233 mg/L means at home
- Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
- Dishwasher: set the water hardness to about 13.6 gpg (13.1 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
- Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
- Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
- Water heater: flush the tank once a year to clear sediment and scale.
Size a softener for your home → Hard water and your water heater →
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Custer County
Prefilled with Custer County's measured local hardness of 233 mg/L (13.6 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Custer County on the South Dakota map
Cities and communities in Custer County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Custer | 176 | Hard | 10 sites within 10 miles |
| Hermosa | 233 | Very hard | county median |
| Buffalo Gap | 224 | Very hard | 30 sites within 10 miles |
| Pringle | 221 | Very hard | 42 sites within 10 miles |
| Fairburn | 233 | Very hard | county median |
Water quality in Custer County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Custer | Custer | Not tested | 0 lead · 0 unknown | None |
| Hermosa | Hermosa-OLD System | Not tested | 0 lead · 99 unknown | None |
| Buffalo Gap | Buffalo Gap | Not tested | 38 lead · 0 unknown | 6 |
| Fairburn | Fairburn Water Association | Not tested | 0 lead · 0 unknown | 3 (1 open) |
Neighboring counties
- Fall River County484 mg/L
- Pennington County261 mg/L
- Lawrence County269 mg/L
- Oglala Lakota County308 mg/L
- Meade County710 mg/L
- Butte County906 mg/L
South Dakota
The statewide median is 410 mg/L (very hard) from 498 sites.
South Dakota hardness map →Hardness scale
What to read next
- Do you need a water softener?Water here is very hard; size a softener with our calculator.
- Hard water and your water heaterHow scale affects your water heater and how often to flush.
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.