Water hardness in Corson County, SD

Water in Corson County is soft, with a median of 30 mg/L (1.8 grains per gallon) across 16 monitoring sites.

93% softer than the South Dakota median (410 mg/L) 54th hardest of 54 counties
30mg/L
1.8 grains per gallon
Soft

Corson County water at a glance

  • HardnessSoft (30 mg/L, 1.8 gpg, local measurements). A water softener isn't needed.Water heater care →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 30 mg/L means at home

  • Water softener: A water softener is generally not needed. Soft water rarely causes scale.
  • Dishwasher: set the water hardness to about 1.8 gpg (1.7 °dH), which is the lowest hardness setting (or softener off).
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites16
Lab samples125
Sample years2000–2018
Middle 50% of sites17–168 mg/L
Groundwater (wells, springs)21 mg/L · 11 sites
Surface water (rivers, lakes)180 mg/L · 5 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Corson County

Prefilled with Corson County's measured local hardness of 30 mg/L (1.8 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Corson County on the South Dakota map

Moody CountyAurora CountyDavison CountyTurner CountyDay CountyFall River CountyBrule CountyMcCook CountyMiner CountyGrant CountyBrown CountyBeadle CountyBrookings CountyClark CountySpink CountyHamlin CountyKingsbury CountyBuffalo CountyEdmunds CountyJerauld CountyHyde CountyDouglas CountySanborn CountyDeuel CountyHutchinson CountyHand CountyLyman CountySully CountyPotter CountyLake CountyHarding CountyHanson CountyUnion CountyYankton CountyGregory CountyCharles Mix CountyMarshall CountyClay CountyLawrence CountyHaakon CountyBon Homme CountyPennington CountyMinnehaha CountyDewey CountyCuster CountyMellette CountyMeade CountyFaulk CountyWalworth CountyTodd CountyButte CountyBennett CountyCodington CountyHughes CountyStanley CountyZiebach CountyRoberts CountyMcPherson CountyLincoln CountyJones CountyOglala Lakota CountyPerkins CountyJackson CountyTripp CountyCampbell County

Cities and communities in Corson County

PlaceMedian mg/LClassBased on
McLaughlin 30 Soft county median
Bullhead (CDP) 30 Soft county median
Little Eagle (CDP) 164 Hard 3 sites within 10 miles
McIntosh 30 Soft county median
Morristown 30 Soft county median
Kenel (CDP) 30 Soft county median
Wakpala (CDP) 188 Very hard 4 sites within 10 miles

Water quality in Corson County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
McLaughlin Mclaughlin Not tested 0 lead · 24 unknown None
McIntosh Mcintosh Not tested 2 lead · 0 unknown 1
Morristown Morristown Not tested 0 lead · 0 unknown 3

Neighboring counties

South Dakota

The statewide median is 410 mg/L (very hard) from 498 sites.

South Dakota hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next