Water hardness in Roosevelt County, NM

Water in Roosevelt County is very hard, with a median of 238 mg/L (13.9 grains per gallon) across 32 monitoring sites.

16% harder than the New Mexico median (205 mg/L) 15th hardest of 32 counties
238mg/L
13.9 grains per gallon
Very hard

Roosevelt County water at a glance

  • HardnessVery hard (238 mg/L, 13.9 gpg, local measurements). Water softeners are common at this level.Size a water softener →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 238 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 13.9 gpg (13.3 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites32
Lab samples80
Sample years2001–2023
Middle 50% of sites189–394 mg/L
Groundwater (wells, springs)238 mg/L · 32 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Roosevelt County

Prefilled with Roosevelt County's measured local hardness of 238 mg/L (13.9 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Roosevelt County on the New Mexico map

Luna CountyLos Alamos CountyDe Baca CountyCurry CountyQuay CountyChaves CountyLincoln CountyEddy CountyHidalgo CountySandoval CountyTaos CountyUnion CountyOtero CountyHarding CountyColfax CountyBernalillo CountySierra CountyCibola CountySanta Fe CountyMora CountyLea CountyRio Arriba CountyDoña Ana CountyGrant CountySan Miguel CountyCatron CountyValencia CountySocorro CountyGuadalupe CountyTorrance CountySan Juan CountyMcKinley County

Cities and communities in Roosevelt County

PlaceMedian mg/LClassBased on
Portales 232 Very hard 7 sites within 10 miles
Elida 238 Very hard county median
Dora 238 Very hard county median
Floyd 238 Very hard county median
Causey 238 Very hard county median

Water quality in Roosevelt County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Portales Portales Water System None detected 0 lead · 3,013 unknown None
Elida Elida Water System Not tested 0 lead · 4 unknown 11
Dora Dora Water System Not tested 0 lead · 0 unknown 2
Floyd Village of Floyd WS Not tested 0 lead · 0 unknown 2
Causey Causey Water System Not tested 0 lead · 25 unknown 2

Neighboring counties

New Mexico

The statewide median is 205 mg/L (very hard) from 1,772 sites.

New Mexico hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next