Water hardness in Curry County, NM

Water in Curry County is very hard, with a median of 270 mg/L (15.7 grains per gallon) across 44 monitoring sites.

32% harder than the New Mexico median (205 mg/L) 13th hardest of 32 counties
270mg/L
15.7 grains per gallon
Very hard

Curry County water at a glance

  • HardnessVery hard (270 mg/L, 15.7 gpg, local measurements). Water softeners are common at this level.Size a water softener →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 270 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 15.7 gpg (15.1 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites44
Lab samples60
Sample years2001–2022
Middle 50% of sites180–333 mg/L
Groundwater (wells, springs)270 mg/L · 44 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Curry County

Prefilled with Curry County's measured local hardness of 270 mg/L (15.8 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Curry County on the New Mexico map

Luna CountyLos Alamos CountyDe Baca CountyQuay CountyChaves CountyLincoln CountyEddy CountyHidalgo CountySandoval CountyTaos CountyUnion CountyOtero CountyHarding CountyColfax CountyBernalillo CountySierra CountyCibola CountySanta Fe CountyMora CountyLea CountyRio Arriba CountyDoña Ana CountyGrant CountySan Miguel CountyCatron CountyValencia CountySocorro CountyRoosevelt CountyGuadalupe CountyTorrance CountySan Juan CountyMcKinley County

Cities and communities in Curry County

PlaceMedian mg/LClassBased on
Clovis 270 Very hard 36 sites within 10 miles
Cannon AFB (CDP) 309 Very hard 29 sites within 10 miles
Texico 174 Hard 9 sites within 10 miles
Melrose 495 Very hard 7 sites within 10 miles
Grady 178 Hard 3 sites within 10 miles

Water quality in Curry County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Clovis Epcor Water New Mexico INC Clovis 1 found 0 lead · 6,113 unknown None
Cannon AFB Cannon Air Force Base Water System 7 found 0 lead · 652 unknown None
Texico Texico Water System Not tested 0 lead · 388 unknown 3
Melrose Melrose Water System Not tested 1 lead · 464 unknown 1
Grady Grady Water System Not tested 0 lead · 0 unknown 5

Neighboring counties

New Mexico

The statewide median is 205 mg/L (very hard) from 1,772 sites.

New Mexico hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next