Water hardness in Chaves County, NM

Water in Chaves County is very hard, with a median of 800 mg/L (46.7 grains per gallon) across 15 monitoring sites.

290% harder than the New Mexico median (205 mg/L) 4th hardest of 32 counties
800mg/L
46.7 grains per gallon
Very hard

Chaves County water at a glance

  • HardnessVery hard (800 mg/L, 46.7 gpg, local measurements). Water softeners are common at this level.Size a water softener →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 800 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 46.7 gpg (44.8 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites15
Lab samples30
Sample years2003–2023
Middle 50% of sites414–1600 mg/L
Groundwater (wells, springs)588 mg/L · 3 sites
Surface water (rivers, lakes)1265 mg/L · 12 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Chaves County

Prefilled with Chaves County's measured local hardness of 800 mg/L (46.8 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Chaves County on the New Mexico map

Luna CountyLos Alamos CountyDe Baca CountyCurry CountyQuay CountyLincoln CountyEddy CountyHidalgo CountySandoval CountyTaos CountyUnion CountyOtero CountyHarding CountyColfax CountyBernalillo CountySierra CountyCibola CountySanta Fe CountyMora CountyLea CountyRio Arriba CountyDoña Ana CountyGrant CountySan Miguel CountyCatron CountyValencia CountySocorro CountyRoosevelt CountyGuadalupe CountyTorrance CountySan Juan CountyMcKinley County

Cities and communities in Chaves County

PlaceMedian mg/LClassBased on
Roswell 1,025 Very hard 8 sites within 10 miles
Dexter 800 Very hard county median
Midway (CDP) 800 Very hard 9 sites within 10 miles
Hagerman 800 Very hard county median
Lake Arthur 800 Very hard county median

Water quality in Chaves County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Roswell Roswell Municipal Water System None detected Not reported 2 (2 open)
Dexter Dexter Municipal Water System Not tested 0 lead · 0 unknown None
Hagerman Hagerman Water System Not tested 0 lead · 0 unknown 1
Lake Arthur Lake Arthur Water Department Not tested 0 lead · 19 unknown 1

Neighboring counties

New Mexico

The statewide median is 205 mg/L (very hard) from 1,772 sites.

New Mexico hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next