Water hardness in Tate County, MS
Water in Tate County is soft, with a median of 32 mg/L (1.9 grains per gallon) across 3 monitoring sites.
Tate County water at a glance
- HardnessSoft (32 mg/L, 1.9 gpg, local measurements). A water softener isn't needed.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 32 mg/L means at home
- Water softener: A water softener is generally not needed. Soft water rarely causes scale.
- Dishwasher: set the water hardness to about 1.9 gpg (1.8 °dH), which is the lowest hardness setting (or softener off).
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Tate County
Prefilled with Tate County's measured local hardness of 32 mg/L (1.9 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Tate County on the Mississippi map
Cities and communities in Tate County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Senatobia | 32 | Soft | county median |
| Coldwater | 38 | Soft | 3 sites within 10 miles |
| Arkabutla (CDP) | 32 | Soft | county median |
| Independence (CDP) | 32 | Soft | county median |
| Strayhorn (CDP) | 65 | Moderately hard | 3 sites within 10 miles |
Water quality in Tate County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Senatobia | City of Senatobia | None detected | 6 lead · 0 unknown | 1 |
| Coldwater | Town of Coldwater | Not tested | 0 lead · 0 unknown | 1 |
Neighboring counties
- DeSoto County31 mg/L
- Panola County29 mg/L
- Tunica County65 mg/L
- Marshall County22 mg/L
- Lafayette County29 mg/L
- Benton County13 mg/L
Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.