Water hardness in Pike County, MS
Water in Pike County is soft, with a median of 6 mg/L (0.3 grains per gallon) across 1 monitoring site.
Pike County water at a glance
- HardnessSoft (6 mg/L, 0.3 gpg, local measurements). A water softener isn't needed.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 6 mg/L means at home
- Water softener: A water softener is generally not needed. Soft water rarely causes scale.
- Dishwasher: set the water hardness to about 0.3 gpg (0.3 °dH), which is the lowest hardness setting (or softener off).
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Pike County
Prefilled with Pike County's measured local hardness of 6 mg/L (0.4 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Pike County on the Mississippi map
Cities and communities in Pike County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| McComb | 6 | Soft | county median |
| Magnolia | 6 | Soft | county median |
| Summit | 6 | Soft | county median |
| Osyka | 6 | Soft | county median |
| Fernwood (CDP) | 6 | Soft | county median |
Water quality in Pike County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| McComb | City of Mccomb | None detected | 1 lead · 4,920 unknown | 1 |
| Magnolia | City of Magnolia | Not tested | 0 lead · 0 unknown | 1 |
| Summit | Town of Summit | Not tested | 0 lead · 0 unknown | 1 |
| Osyka | Town of Osyka | Not tested | 0 lead · 0 unknown | None |
Neighboring counties
- Walthall County10 mg/L
- Lincoln County11 mg/L
- Lawrence County14 mg/L
- Franklin County983 mg/L
- Jefferson Davis County15 mg/L
- Copiah County18 mg/L
Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.