Water hardness in Brooklyn Park, MD

Water in Brooklyn Park is moderately hard, with a median of 73 mg/L (4.3 grains per gallon) across 14 monitoring sites within 10 miles.

30% harder than the Maryland median (56 mg/L) 68th hardest of 121 Maryland towns Population 14,373 (2010)
73mg/L
4.3 grains per gallon
Moderately hard

Brooklyn Park tap water at a glance

  • HardnessModerately hard (73 mg/L, 4.3 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 73 mg/L means at home

  • Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
  • Dishwasher: set the water hardness to about 4.3 gpg (4.1 °dH), which is a low-to-medium hardness setting.
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites14
Lab samples14
Sample years2000–2016
Middle 50% of sites24–128 mg/L
Groundwater (wells, springs)49 mg/L · 11 sites
Surface water (rivers, lakes)130 mg/L · 3 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Brooklyn Park

Prefilled with Brooklyn Park's measured local hardness of 73 mg/L (4.3 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Monitoring sites closest to Brooklyn Park

SiteTypeDistanceMedianSamplesYears
PATAPSCO RIVER TRIBUTARY AT HALETHORPE, MD
USGS Maryland Water Science Center
Stream 2.5 mi145 mg/L12000
UNNAMED TRIB TO PATAPSCO RIVER NEAR PATAPSCO, MD
USGS Maryland Water Science Center
Stream 3.1 mi95 mg/L12000
AA Ad 102
USGS Maryland Water Science Center
Well 3.4 mi23 mg/L12003
AA Ad 110
USGS Maryland Water Science Center
Well 3.4 mi91 mg/L12002
3S2E- 5
USGS Maryland Water Science Center
Well 3.6 mi402 mg/L12003
GWYNNS FALLS AT WASHINGTON BLVD AT BALTIMORE, MD
USGS Maryland Water Science Center
Stream 4 mi130 mg/L12000

Water hardness in towns near Brooklyn Park

TownDistanceMedianClass
Ferndale2 mi 39 mg/LSoft
Linthicum2 mi 39 mg/LSoft
Arbutus4 mi 55 mg/LSoft
Glen Burnie4 mi 25 mg/LSoft
Pasadena5 mi 37 mg/LSoft
Baltimore6 mi 266 mg/LVery hard
Riviera Beach6 mi 24 mg/LSoft
Elkridge7 mi 49 mg/LSoft
Severn7 mi 23 mg/LSoft
Catonsville7 mi 71 mg/LModerately hard

Anne Arundel County

Brooklyn Park is in Anne Arundel County, where the median is 95 mg/L (moderately hard) across 57 sites.

See all of Anne Arundel County →

Maryland

The statewide median is 56 mg/L (soft) from 1,412 sites.

Maryland hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next