Water hardness in McNairy County, TN
Water in McNairy County is soft, with a median of 22 mg/L (1.3 grains per gallon) across 49 monitoring sites.
McNairy County water at a glance
- HardnessSoft (22 mg/L, 1.3 gpg, local measurements). A water softener isn't needed.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 22 mg/L means at home
- Water softener: A water softener is generally not needed. Soft water rarely causes scale.
- Dishwasher: set the water hardness to about 1.3 gpg (1.2 °dH), which is the lowest hardness setting (or softener off).
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for McNairy County
Prefilled with McNairy County's measured local hardness of 22 mg/L (1.3 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
McNairy County on the Tennessee map
Cities and communities in McNairy County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Selmer | 20 | Soft | 29 sites within 10 miles |
| Eastview | 26 | Soft | 25 sites within 10 miles |
| Bethel Springs | 16 | Soft | 21 sites within 10 miles |
| Michie | 32 | Soft | 19 sites within 10 miles |
| Guys | 32 | Soft | 19 sites within 10 miles |
| Stantonville | 27 | Soft | 26 sites within 10 miles |
| Ramer | 24 | Soft | 29 sites within 10 miles |
| Finger | 13 | Soft | 10 sites within 10 miles |
| Chewalla (CDP) | 24 | Soft | 23 sites within 10 miles |
Water quality in McNairy County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Selmer | Selmer Water System | None detected | 0 lead · 0 unknown | None |
| Eastview | Eastview Utility District | Not tested | 0 lead · 816 unknown | None |
| Bethel Springs | Bethel Springs Water System | Not tested | 0 lead · 456 unknown | None |
| Michie | Michie Water Dept | Not tested | 0 lead · 0 unknown | None |
Neighboring counties
- Chester County13 mg/L
- Hardin County27 mg/L
- Hardeman County20 mg/L
- Madison County18 mg/L
- Henderson County15 mg/L
- Decatur County94 mg/L
Tennessee
The statewide median is 98 mg/L (moderately hard) from 3,359 sites.
Tennessee hardness map →Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.