Water hardness in Merrimack County, NH
Water in Merrimack County is soft, with a median of 15 mg/L (0.9 grains per gallon) across 30 monitoring sites.
Merrimack County water at a glance
- HardnessSoft (15 mg/L, 0.9 gpg, local measurements). A water softener isn't needed.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 15 mg/L means at home
- Water softener: A water softener is generally not needed. Soft water rarely causes scale.
- Dishwasher: set the water hardness to about 0.9 gpg (0.8 °dH), which is the lowest hardness setting (or softener off).
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Merrimack County
Prefilled with Merrimack County's measured local hardness of 15 mg/L (0.9 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Merrimack County on the New Hampshire map
Cities and communities in Merrimack County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Concord | 25 | Soft | 11 sites within 10 miles |
| Franklin | 22 | Soft | 6 sites within 10 miles |
| South Hooksett (CDP) | 22 | Soft | 24 sites within 10 miles |
| Suncook (CDP) | 14 | Soft | 21 sites within 10 miles |
| Hooksett (CDP) | 15 | Soft | 21 sites within 10 miles |
| Henniker (CDP) | 16 | Soft | 9 sites within 10 miles |
| Pittsfield (CDP) | 14 | Soft | 8 sites within 10 miles |
| Contoocook (CDP) | 18 | Soft | 11 sites within 10 miles |
| New London (CDP) | 20 | Soft | 5 sites within 10 miles |
| Loudon (CDP) | 15 | Soft | 14 sites within 10 miles |
| Warner (CDP) | 17 | Soft | 8 sites within 10 miles |
| Bradford (CDP) | 15 | Soft | 6 sites within 10 miles |
| Blodgett Landing (CDP) | 15 | Soft | 9 sites within 10 miles |
Water quality in Merrimack County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Concord | Concord Water Dept | None detected | 0 lead · 749 unknown | None |
| Franklin | Franklin Water Works | None detected | 0 lead · 1,577 unknown | None |
| Hooksett | Central Hooksett Water PCT | 2 found (PFOA 4.9 / PFOS ND ppt) | 0 lead · 0 unknown | None |
| Henniker | Cogswell Springs Water Works | Not tested | 0 lead · 570 unknown | None |
| Pittsfield | Pittsfield Aqueduct | Not tested | 0 lead · 407 unknown | None |
| New London | New London Springfield Water | None detected | 0 lead · 161 unknown | None |
| Loudon | Villages AT Loudon | Not tested | Not reported | None |
| Warner | Warner Village Water Dist | Not tested | 0 lead · 314 unknown | None |
| Bradford | Fisherfield Townhouses | Not tested | 0 lead · 8 unknown | None |
Neighboring counties
- Belknap County14 mg/L
- Hillsborough County19 mg/L
- Sullivan County36 mg/L
- Strafford County12 mg/L
- Rockingham County50 mg/L
- Cheshire County16 mg/L
Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.