Water hardness in Wapello County, IA
Water in Wapello County is very hard, with a median of 393 mg/L (23 grains per gallon) across 2 monitoring sites.
Wapello County water at a glance
- HardnessVery hard (393 mg/L, 23 gpg, local measurements). Water softeners are common at this level.Size a water softener →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 393 mg/L means at home
- Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
- Dishwasher: set the water hardness to about 23 gpg (22 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
- Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
- Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
- Water heater: flush the tank once a year to clear sediment and scale.
Size a softener for your home → Hard water and your water heater →
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Wapello County
Prefilled with Wapello County's measured local hardness of 393 mg/L (23 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Wapello County on the Iowa map
Cities and communities in Wapello County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Ottumwa | 393 | Very hard | county median |
| Eldon | 393 | Very hard | county median |
| Agency | 393 | Very hard | county median |
| Blakesburg | 393 | Very hard | county median |
| Kirkville | 393 | Very hard | county median |
| Chillicothe | 393 | Very hard | county median |
Water quality in Wapello County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Ottumwa | Ottumwa Water Works | None detected | 0 lead · 0 unknown | None |
| Eldon | Eldon Water Supply | Not tested | 7 lead · 48 unknown | None |
| Agency | Agency Water Works | Not tested | 0 lead · 0 unknown | None |
| Blakesburg | Blakesburg Municipal Water Works | Not tested | 0 lead · 0 unknown | None |
Neighboring counties
- Jefferson County315 mg/L
- Mahaska County305 mg/L
- Keokuk County330 mg/L
- Van Buren County266 mg/L
- Washington County314 mg/L
- Marion County270 mg/L
Hardness scale
What to read next
- Do you need a water softener?Water here is very hard; size a softener with our calculator.
- Hard water and your water heaterHow scale affects your water heater and how often to flush.
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.