Water hardness in Howard County, AR
Water in Howard County is soft, with a median of 20 mg/L (1.2 grains per gallon) across 36 monitoring sites.
Howard County water at a glance
- HardnessSoft (20 mg/L, 1.2 gpg, local measurements). A water softener isn't needed.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 20 mg/L means at home
- Water softener: A water softener is generally not needed. Soft water rarely causes scale.
- Dishwasher: set the water hardness to about 1.2 gpg (1.1 °dH), which is the lowest hardness setting (or softener off).
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Howard County
Prefilled with Howard County's measured local hardness of 20 mg/L (1.2 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Howard County on the Arkansas map
Cities and communities in Howard County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Nashville | 21 | Soft | 17 sites within 10 miles |
| Mineral Springs | 20 | Soft | 24 sites within 10 miles |
| Dierks | 13 | Soft | 9 sites within 10 miles |
| Tollette | 23 | Soft | 22 sites within 10 miles |
| Center Point (CDP) | 21 | Soft | 13 sites within 10 miles |
Water quality in Howard County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Nashville | Nashville Waterworks | 1 found | 0 lead · 1,729 unknown | None |
| Mineral Springs | Mineral Springs Waterworks | Not tested | 0 lead · 971 unknown | None |
| Dierks | Dierks Water Works | Not tested | 0 lead · 417 unknown | 1 |
| Tollette | Tollette Water | Not tested | 0 lead · 0 unknown | None |
Neighboring counties
- Sevier County20 mg/L
- Pike County40 mg/L
- Little River County100 mg/L
- Hempstead County22 mg/L
- Polk County13 mg/L
- Montgomery County22 mg/L
Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.