Water hardness in Garland County, AR
Water in Garland County is soft, with a median of 32 mg/L (1.9 grains per gallon) across 68 monitoring sites.
Garland County water at a glance
- HardnessSoft (32 mg/L, 1.9 gpg, local measurements). A water softener isn't needed.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 32 mg/L means at home
- Water softener: A water softener is generally not needed. Soft water rarely causes scale.
- Dishwasher: set the water hardness to about 1.9 gpg (1.8 °dH), which is the lowest hardness setting (or softener off).
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Garland County
Prefilled with Garland County's measured local hardness of 32 mg/L (1.9 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Garland County on the Arkansas map
Cities and communities in Garland County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Hot Springs | 26 | Soft | 62 sites within 10 miles |
| Hot Springs Village (CDP) | 19 | Soft | 36 sites within 10 miles |
| Piney (CDP) | 46 | Soft | 38 sites within 10 miles |
| Rockwell (CDP) | 44 | Soft | 43 sites within 10 miles |
| Lake Hamilton (CDP) | 28 | Soft | 50 sites within 10 miles |
| Mountain Pine | 131 | Hard | 21 sites within 10 miles |
| Fountain Lake | 48 | Soft | 46 sites within 10 miles |
| Lonsdale | 37 | Soft | 55 sites within 10 miles |
| Crystal Springs (CDP) | 28 | Soft | 5 sites within 10 miles |
| Pearcy (CDP) | 28 | Soft | 5 sites within 10 miles |
Water quality in Garland County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Hot Springs | Hot Springs Utilities | None detected | 0 lead · 28,032 unknown | 1 |
| Hot Springs Village | Hot Springs Village Waterworks | None detected | 0 lead · 3,735 unknown | None |
| Mountain Pine | Mountain Pine Waterworks | Not tested | 0 lead · 212 unknown | None |
Neighboring counties
- Hot Spring County27 mg/L
- Saline County52 mg/L
- Perry County14 mg/L
- Montgomery County22 mg/L
- Yell County17 mg/L
- Clark County21 mg/L
Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.