Water hardness in Washington County, RI

Water in Washington County is soft, with a median of 35 mg/L (2 grains per gallon) across 5 monitoring sites.

84% harder than the Rhode Island median (19 mg/L) 2nd hardest of 3 counties
35mg/L
2 grains per gallon
Soft

Washington County water at a glance

  • HardnessSoft (35 mg/L, 2 gpg, local measurements). A water softener isn't needed.Water heater care →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 35 mg/L means at home

  • Water softener: A water softener is generally not needed. Soft water rarely causes scale.
  • Dishwasher: set the water hardness to about 2 gpg (2 °dH), which is the lowest hardness setting (or softener off).
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites5
Lab samples200
Sample years2000–2023
Middle 50% of sites16–50 mg/L
Groundwater (wells, springs)50 mg/L · 3 sites
Surface water (rivers, lakes)14 mg/L · 2 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Washington County

Prefilled with Washington County's measured local hardness of 35 mg/L (2 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Washington County on the Rhode Island map

Bristol CountyNewport CountyKent CountyProvidence County

Cities and communities in Washington County

PlaceMedian mg/LClassBased on
Westerly (CDP) 35 Soft county median
Kingston (CDP) 35 Soft county median
Narragansett Pier (CDP) 35 Soft county median
Hope Valley (CDP) 50 Soft 3 sites within 10 miles
Ashaway (CDP) 35 Soft county median
Bradford (CDP) 35 Soft county median
Carolina (CDP) 50 Soft 3 sites within 10 miles
Weekapaug (CDP) 35 Soft county median
Misquamicut (CDP) 35 Soft county median
Quonochontaug (CDP) 35 Soft county median
Wyoming (CDP) 50 Soft 3 sites within 10 miles
Watch Hill (CDP) 35 Soft county median
Charlestown (CDP) 35 Soft county median
Hopkinton (CDP) 16 Soft 3 sites within 10 miles
Wakefield-Peace Dale (CDP) 35 Soft county median

Water quality in Washington County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Westerly Westerly Water Department 7 found (PFOA 9 / PFOS 7 ppt) 1,362 lead · 1,051 unknown None
Kingston Kingston Water District 5 found (PFOA 6.2 / PFOS ND ppt) 0 lead · 0 unknown None
Charlestown Charlestown Cedars LLC Not tested 0 lead · 0 unknown None
Hopkinton Town of Hopkinton Not tested 0 lead · 0 unknown 1

Neighboring counties

Rhode Island

The statewide median is 19 mg/L (soft) from 35 sites.

Rhode Island hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next