Water hardness in Klamath County, OR
Water in Klamath County is soft, with a median of 54 mg/L (3.2 grains per gallon) across 138 monitoring sites.
Klamath County water at a glance
- HardnessSoft (54 mg/L, 3.2 gpg, local measurements). A water softener isn't needed.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 54 mg/L means at home
- Water softener: A water softener is generally not needed. Soft water rarely causes scale.
- Dishwasher: set the water hardness to about 3.2 gpg (3 °dH), which is the lowest hardness setting (or softener off).
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Klamath County
Prefilled with Klamath County's measured local hardness of 54 mg/L (3.2 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Klamath County on the Oregon map
Cities and communities in Klamath County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Klamath Falls | 78 | Moderately hard | 40 sites within 10 miles |
| Altamont (CDP) | 78 | Moderately hard | 40 sites within 10 miles |
| Merrill | 78 | Moderately hard | 16 sites within 10 miles |
| Chiloquin | 51 | Soft | 23 sites within 10 miles |
| Malin | 74 | Moderately hard | 8 sites within 10 miles |
| Bonanza | 118 | Moderately hard | 8 sites within 10 miles |
| Beatty (CDP) | 24 | Soft | 5 sites within 10 miles |
| Beaver Marsh (CDP) | 20 | Soft | 3 sites within 10 miles |
| Bly (CDP) | 18 | Soft | 4 sites within 10 miles |
| Chemult (CDP) | 20 | Soft | 3 sites within 10 miles |
| Crescent (CDP) | 54 | Soft | county median |
| Crescent Lake (CDP) | 11 | Soft | 9 sites within 10 miles |
| Falcon Heights (CDP) | 85 | Moderately hard | 50 sites within 10 miles |
| Fort Klamath (CDP) | 28 | Soft | 9 sites within 10 miles |
| Gilchrist (CDP) | 23 | Soft | 9 sites within 10 miles |
| Keno (CDP) | 77 | Moderately hard | 33 sites within 10 miles |
| Oregon Shores (CDP) | 51 | Soft | 23 sites within 10 miles |
| Rocky Point (CDP) | 20 | Soft | 5 sites within 10 miles |
| Running Y Ranch (CDP) | 76 | Moderately hard | 20 sites within 10 miles |
| Sprague River (CDP) | 103 | Moderately hard | 6 sites within 10 miles |
Water quality in Klamath County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Klamath Falls | Klamath Falls Water Dept | 3 found (PFOA ND / PFOS 9.5 ppt) | 0 lead · 0 unknown | None |
| Merrill | Merrill Water Department | Not tested | 0 lead · 0 unknown | None |
| Chiloquin | Chiloquin Municipal Water Dept | Not tested | 0 lead · 2 unknown | None |
| Malin | Malin Municipal Water | Not tested | 0 lead · 0 unknown | 1 (1 open) |
| Bly | BLY Water District | Not tested | 0 lead · 0 unknown | 1 |
| Falcon Heights | Falcon Heights | Not tested | 0 lead · 0 unknown | 1 |
| Keno | Keno Water Co INC | Not tested | 0 lead · 0 unknown | None |
Neighboring counties
- Jackson County172 mg/L
- Lake County53 mg/L
- Douglas County43 mg/L
- Deschutes County40 mg/L
- Josephine County97 mg/L
- Lane County95 mg/L
Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.