Water hardness in Mille Lacs County, MN
Water in Mille Lacs County is moderately hard, with a median of 101 mg/L (5.9 grains per gallon) across 9 monitoring sites.
Mille Lacs County water at a glance
- HardnessModerately hard (101 mg/L, 5.9 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 101 mg/L means at home
- Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
- Dishwasher: set the water hardness to about 5.9 gpg (5.7 °dH), which is a low-to-medium hardness setting.
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Mille Lacs County
Prefilled with Mille Lacs County's measured local hardness of 101 mg/L (5.9 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Mille Lacs County on the Minnesota map
Cities and communities in Mille Lacs County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Milaca | 101 | Moderately hard | 5 sites within 10 miles |
| Vineland (CDP) | 110 | Moderately hard | 7 sites within 10 miles |
| Onamia | 101 | Moderately hard | county median |
| Isle | 101 | Moderately hard | county median |
| Foreston | 101 | Moderately hard | 5 sites within 10 miles |
| Wahkon | 101 | Moderately hard | county median |
| Pease | 164 | Hard | 6 sites within 10 miles |
| Bock | 96 | Moderately hard | 6 sites within 10 miles |
Water quality in Mille Lacs County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Milaca | Milaca | Not tested | 0 lead · 846 unknown | None |
| Onamia | Onamia | Not tested | 0 lead · 171 unknown | None |
| Isle | Isle | Not tested | 0 lead · 97 unknown | None |
| Foreston | Foreston | Not tested | 0 lead · 139 unknown | None |
| Pease | Pease | Not tested | 0 lead · 0 unknown | None |
| Bock | Bock | Not tested | 0 lead · 0 unknown | None |
Neighboring counties
- Kanabec County72 mg/L
- Benton County145 mg/L
- Isanti County122 mg/L
- Morrison County170 mg/L
- Sherburne County210 mg/L
- Pine County56 mg/L
Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.