Water hardness in Hancock County, ME

Water in Hancock County is soft, with a median of 14 mg/L (0.8 grains per gallon) across 31 monitoring sites.

68% softer than the Maine median (44 mg/L) 11th hardest of 15 counties
14mg/L
0.8 grains per gallon
Soft

Hancock County water at a glance

  • HardnessSoft (14 mg/L, 0.8 gpg, local measurements). A water softener isn't needed.Water heater care →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 14 mg/L means at home

  • Water softener: A water softener is generally not needed. Soft water rarely causes scale.
  • Dishwasher: set the water hardness to about 0.8 gpg (0.8 °dH), which is the lowest hardness setting (or softener off).
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites31
Lab samples151
Sample years2000–2007
Middle 50% of sites8–46 mg/L
Groundwater (wells, springs)46 mg/L · 15 sites
Surface water (rivers, lakes)8 mg/L · 16 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Hancock County

Prefilled with Hancock County's measured local hardness of 14 mg/L (0.8 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Hancock County on the Maine map

Aroostook CountyYork CountyWashington CountyKnox CountyOxford CountyAndroscoggin CountySagadahoc CountyFranklin CountySomerset CountyKennebec CountyWaldo CountyPiscataquis CountyPenobscot CountyLincoln CountyCumberland County

Cities and communities in Hancock County

PlaceMedian mg/LClassBased on
Ellsworth 46 Soft 6 sites within 10 miles
Bucksport (CDP) 14 Soft county median
Bar Harbor (CDP) 9 Soft 15 sites within 10 miles
Castine (CDP) 72 Moderately hard 4 sites within 10 miles
Blue Hill (CDP) 45 Soft 7 sites within 10 miles
Southwest Harbor (CDP) 8 Soft 17 sites within 10 miles
Winter Harbor (CDP) 7 Soft 6 sites within 10 miles
Northeast Harbor (CDP) 9 Soft 18 sites within 10 miles

Water quality in Hancock County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Ellsworth Ellsworth Water Department None detected 2 lead · 68 unknown 5
Bucksport Maine Water Company Bucksport Division Not tested 0 lead · 0 unknown None
Bar Harbor Town of Bar Harbor- Water Division 2 found 0 lead · 0 unknown None
Castine Castine Water Department Not tested 0 lead · 53 unknown None
Blue Hill Blue Hill Terrace Not tested 0 lead · 0 unknown 4
Southwest Harbor Southwest Harbor Water & Sewer District Not tested 0 lead · 133 unknown 7
Winter Harbor Winter Harbor Water District Not tested 0 lead · 105 unknown None

Neighboring counties

Maine

The statewide median is 44 mg/L (soft) from 251 sites.

Maine hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next