Water hardness in Marshall County, KY
Water in Marshall County is soft, with a median of 48 mg/L (2.8 grains per gallon) across 2 monitoring sites.
Marshall County water at a glance
- HardnessSoft (48 mg/L, 2.8 gpg, local measurements). A water softener isn't needed.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 48 mg/L means at home
- Water softener: A water softener is generally not needed. Soft water rarely causes scale.
- Dishwasher: set the water hardness to about 2.8 gpg (2.7 °dH), which is the lowest hardness setting (or softener off).
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Marshall County
Prefilled with Marshall County's measured local hardness of 48 mg/L (2.8 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Marshall County on the Kentucky map
Cities and communities in Marshall County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Benton | 48 | Soft | county median |
| Calvert City | 86 | Moderately hard | 7 sites within 10 miles |
| Hardin | 48 | Soft | county median |
| Gilbertsville (CDP) | 88 | Moderately hard | 6 sites within 10 miles |
Water quality in Marshall County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Benton | Benton Water & Sewer | None detected | 0 lead · 0 unknown | None |
| Calvert City | Calvert City Municipal Water Department | None detected | 0 lead · 1,063 unknown | None |
| Hardin | Hardin Water Department | Not tested | 0 lead · 0 unknown | None |
Neighboring counties
- Lyon County100 mg/L
- Calloway County20 mg/L
- Graves County18 mg/L
- Livingston County92 mg/L
- McCracken County68 mg/L
- Trigg County186 mg/L
Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.