Water hardness in Sumner County, KS
Water in Sumner County is very hard, with a median of 246 mg/L (14.4 grains per gallon) across 37 monitoring sites.
Sumner County water at a glance
- HardnessVery hard (246 mg/L, 14.4 gpg, local measurements). Water softeners are common at this level.Size a water softener →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 246 mg/L means at home
- Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
- Dishwasher: set the water hardness to about 14.4 gpg (13.8 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
- Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
- Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
- Water heater: flush the tank once a year to clear sediment and scale.
Size a softener for your home → Hard water and your water heater →
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Sumner County
Prefilled with Sumner County's measured local hardness of 246 mg/L (14.4 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Sumner County on the Kansas map
Cities and communities in Sumner County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Wellington | 245 | Very hard | 8 sites within 10 miles |
| Belle Plaine | 241 | Very hard | 26 sites within 10 miles |
| Conway Springs | 246 | Very hard | county median |
| Oxford | 254 | Very hard | 28 sites within 10 miles |
| Caldwell | 300 | Very hard | 4 sites within 10 miles |
| Argonia | 246 | Very hard | county median |
| South Haven | 405 | Very hard | 3 sites within 10 miles |
| Milton (CDP) | 220 | Very hard | 5 sites within 10 miles |
| Mayfield | 200 | Very hard | 3 sites within 10 miles |
| Milan | 212 | Very hard | 4 sites within 10 miles |
| Hunnewell | 352 | Very hard | 4 sites within 10 miles |
Water quality in Sumner County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Wellington | City of Wellington | 1 found | 12 lead · 3,653 unknown | 1 |
| Belle Plaine | City of Belle Plaine | Not tested | 0 lead · 676 unknown | 16 |
| Conway Springs | City of Conway Springs | Not tested | 0 lead · 296 unknown | 9 |
| Oxford | City of Oxford | Not tested | 2 lead · 399 unknown | None |
| Caldwell | City of Caldwell | Not tested | 0 lead · 146 unknown | None |
| Argonia | City of Argonia | Not tested | 0 lead · 1 unknown | 7 |
| South Haven | City of South Haven | Not tested | 0 lead · 118 unknown | None |
| Mayfield | City of Mayfield | Not tested | Not reported | None |
Neighboring counties
- Sedgwick County262 mg/L
- Harper County240 mg/L
- Cowley County237 mg/L
- Kingman County220 mg/L
- Butler County235 mg/L
- Harvey County205 mg/L
Hardness scale
What to read next
- Do you need a water softener?Water here is very hard; size a softener with our calculator.
- Hard water and your water heaterHow scale affects your water heater and how often to flush.
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.