Water hardness in Juneau City and Borough, AK
Water in Juneau City and Borough is moderately hard, with a median of 64 mg/L (3.7 grains per gallon) across 4 monitoring sites.
Juneau City and Borough water at a glance
- HardnessModerately hard (64 mg/L, 3.7 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 64 mg/L means at home
- Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
- Dishwasher: set the water hardness to about 3.7 gpg (3.6 °dH), which is a low-to-medium hardness setting.
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Juneau City and Borough
Prefilled with Juneau City and Borough's measured local hardness of 64 mg/L (3.7 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Juneau City and Borough on the Alaska map
Cities and communities in Juneau City and Borough
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Juneau | 64 | Moderately hard | county median |
Water quality in Juneau City and Borough communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Juneau | City and Borough of Juneau | None detected | 0 lead · 7,917 unknown | None |
Neighboring counties
- Hoonah-Angoon Census Area78 mg/L
- Haines Borough89 mg/L
- Skagway Municipality30 mg/L
- Sitka City and Borough15 mg/L
- Petersburg Borough5 mg/L
- Wrangell City and Borough59 mg/L
Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.