Water hardness in Autauga County, AL
Water in Autauga County is soft, with a median of 10 mg/L (0.6 grains per gallon) across 15 monitoring sites.
Autauga County water at a glance
- HardnessSoft (10 mg/L, 0.6 gpg, local measurements). A water softener isn't needed.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 10 mg/L means at home
- Water softener: A water softener is generally not needed. Soft water rarely causes scale.
- Dishwasher: set the water hardness to about 0.6 gpg (0.6 °dH), which is the lowest hardness setting (or softener off).
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Autauga County
Prefilled with Autauga County's measured local hardness of 10 mg/L (0.6 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Autauga County on the Alabama map
Cities and communities in Autauga County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Prattville | 33 | Soft | 27 sites within 10 miles |
| Pine Level (CDP) | 17 | Soft | 14 sites within 10 miles |
| Marbury (CDP) | 14 | Soft | 11 sites within 10 miles |
| Autaugaville | 30 | Soft | 8 sites within 10 miles |
| Billingsley | 10 | Soft | 8 sites within 10 miles |
Water quality in Autauga County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Prattville | Prattville (Water Works Board of) | 7 found (PFOA 19.2 / PFOS 22.8 ppt) | 0 lead · 33 unknown | None |
| Pine Level | Pine Level Water Authority | Not tested | 0 lead · 0 unknown | None |
| Marbury | Marbury Water System, INC. | 7 found (PFOA 16.1 / PFOS 20.2 ppt) | 0 lead · 418 unknown | None |
| Autaugaville | Autaugaville Water Works | Not tested | 0 lead · 1 unknown | None |
| Billingsley | Billingsley Water System | Not tested | 0 lead · 0 unknown | None |
Neighboring counties
- Chilton County22 mg/L
- Lowndes County64 mg/L
- Elmore County17 mg/L
- Dallas County61 mg/L
- Montgomery County41 mg/L
- Coosa County13 mg/L
Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.