Uranium in well water
Updated November 21, 2026 · Based on EPA and other public sources listed below · How we make our content
Short answer: uranium comes naturally from some bedrock, so it shows up mainly in drilled wells. Health Canada's limit is 0.02 mg/L (20 µg/L), based on effects on the kidneys from long-term exposure. You can't see, smell or taste it, so the only way to know is a lab test. Reverse osmosis, ion exchange and distillation can remove it.
Which wells are most likely to have uranium
- Drilled wells in bedrock. Alberta Health Services says levels are higher when well water flows from cracks in bedrock; Nova Scotia says high levels are more likely in drilled wells than in dug wells or surface water.
- Certain rock types. In Nova Scotia, wells in areas with granite or alkaline sandstone and shale bedrock are most likely to have high levels. The province measured uranium in drinking water between 0.005 and 0.83 mg/L.
- Across Canada, Health Canada says levels vary greatly depending mainly on geological formations.
City and town water is tested regularly for uranium, Alberta Health Services notes, so this is mainly a question for private well owners.
Health effects
Health Canada says exposure to high levels for a long time could affect the kidneys and bones, and that short-term exposure should not have a negative impact. Its 0.02 mg/L limit is based on kidney effects. Health Canada also says uranium does not enter the body through intact skin or by breathing vapours in the shower or bath.
If your test is above 0.02 mg/L
- Use another water source for drinking and cooking (Alberta also says brushing teeth), and test again to confirm the result.
- Treat the water (below), or, as Nova Scotia suggests, switch to a dug well or surface water.
Treatment options
| Treatment | Where it goes | Named by |
|---|---|---|
| Reverse osmosis | One tap (point of use) | Health Canada, Nova Scotia, Alberta |
| Ion exchange (anion exchange) | Where water enters the home, installed by specialists | Health Canada, Alberta |
| Distillation | Countertop or point of use | Nova Scotia, Alberta |
Health Canada has said there are no certified residential treatment units specifically for uranium, so it recommends testing the water going into and coming out of the unit regularly to make sure it works. Compare with other limits in Canadian drinking water guidelines; Health Canada also says groundwater should be tested for both uranium and nitrate.
Drilled wells in granite can also have radon.
Frequently asked questions
What is the limit for uranium in drinking water in Canada?
Health Canada's maximum acceptable concentration is 0.02 mg/L (20 µg/L) for total natural uranium.
What are the health effects of uranium in well water?
Health Canada says long-term exposure to high levels could affect the kidneys and bones, and that short-term exposure should not have a negative impact. The concern is chemical, not radiation: Alberta Health Services says radiation from high levels of uranium is not known to cause cancer.
How do I know if my well has uranium?
You can't see, smell or taste it; the only way to know is to test the water at an accredited lab. Drilled wells in bedrock are more likely to have high levels than dug wells or surface water.
How do you remove uranium from well water?
Reverse osmosis at one tap, ion exchange where the water enters the home, or distillation. Health Canada has said there are no certified residential units for uranium, so test the water before and after treatment to check the unit works.
Is it OK to shower in water with uranium?
Health Canada says uranium will not enter the body through intact skin or by breathing in vapours while showering or bathing.