Why is my faucet dripping?

Updated November 21, 2026 · Based on EPA and other public sources listed below · How we make our content

Short answer: a dripping faucet (or tap) is usually caused by a worn washer or gasket, according to EPA. One drip per second can waste more than 3,000 gallons a year, EPA says. Replacing the washer, O-ring or cartridge usually stops it.

How much water a drip wastes

Drips per minuteGallons per yearLitres per year
135131
5174657
103471,314
301,0413,942
60 (one per second)2,0837,884

Calculated with USGS's assumption of 1/4 millilitre per drip (15,140 drips per gallon). EPA's own estimate for one drip per second is higher, more than 3,000 gallons a year, because real drips vary in size.

Why faucets drip

  • Worn washer or gasket. EPA names old and worn washers and gaskets as a frequent cause. In compression faucets (separate hot and cold handles that you screw shut), the rubber washer hardens and stops sealing.
  • Worn O-ring or cartridge. Single-handle faucets seal with a cartridge or O-rings; a drip from the spout usually means the cartridge needs replacing.
  • Mineral scale. Hard water leaves scale on valve seats and cartridges, which can stop parts from sealing. Check your town on the water hardness map.

Fix it

  1. Turn off the shut-off valves under the sink (or the main supply).
  2. Plug the drain so small parts can't fall in, and take a photo before you take the handle apart.
  3. Take the worn washer, O-ring or cartridge to a hardware store to match it.
  4. Reassemble, turn the water back on slowly and check for drips.

If you replace the faucet, EPA says WaterSense bathroom faucets and aerators use at most 1.5 gallons per minute instead of the standard 2.2, saving the average family 700 gallons a year.

Other hidden leaks: a running toilet and a leaking water heater. Weak flow from the tap instead? See low water pressure.

Frequently asked questions

Why is my faucet dripping?

EPA says old and worn faucet washers and gaskets frequently cause leaks. Replacing the washer, O-ring or cartridge usually stops the drip.

How much water does a dripping faucet waste?

EPA says a faucet that drips one drip per second can waste more than 3,000 gallons a year. Using USGS's assumption of 15,140 drips per gallon, one drip per second is about 2,100 gallons (7,900 litres) a year; the exact amount depends on drip size.

Is a dripping tap the same as a dripping faucet?

Yes. Tap is the usual word in Australia, New Zealand and the UK; faucet is the usual word in the US. The causes and fixes are the same.

Does a new faucet or aerator save water?

EPA says WaterSense bathroom faucets and aerators use at most 1.5 gallons per minute instead of the standard 2.2, saving the average family 700 gallons a year.

Sources

Related guides