Why is my water pressure low?
Updated November 21, 2026 · Based on EPA and other public sources listed below · How we make our content
Short answer: if one faucet or shower is weak, it is usually a clogged aerator or a scaled-up showerhead. If the whole house is weak, check that the main valve is fully open, that your pressure-reducing valve still works, and look for leaks. EPA says pressure works best between 45 and 60 psi.
Low pressure or low flow?
Denver Water and Portland Water Bureau both point out that what people call low pressure is often low flow: the pressure in the main is fine, but something in the home's pipes or fixtures restricts how much water gets through. That is good news, because most flow problems can be fixed inside the house.
Check these, in order
- Is it one fixture or all of them? Run several taps. If only one is weak, go to step 2; if all are, go to step 3.
- Clean the aerator or showerhead. Unscrew the aerator screen at the tip of the faucet and rinse it; Portland recommends this first. EPA advises inspecting showerheads for scale buildup; mineral scale from hard water slowly blocks the small holes.
- Open every valve fully. Portland's first whole-house check is that all valves inside the home are all the way open, including the main shutoff, which is sometimes left partly closed after plumbing work.
- Check the pressure-reducing valve (PRV) and any whole-house filter. A PRV lowers high street pressure; when it fails it can cut pressure. A clogged whole-house filter cartridge restricts flow too.
- Look for leaks. EPA says a drop in pressure can mean a leak in your home. A running toilet or a leaking water heater are common ones.
- Ask your utility. Portland notes that water main breaks and other system events can cause temporary pressure changes, and that some homes always receive lower pressure because of their elevation.
How to test your water pressure
Buy an inexpensive pressure gauge at a hardware store. EPA's method: turn off all water use in the house, screw the gauge onto an outdoor hose faucet (hose bibb), open the faucet fully and read the pressure.
| Reading | What the sources say |
|---|---|
| 45–60 psi | EPA: the range where water pressure works best |
| 40–80 psi | Portland Water Bureau: where it keeps most homes |
| Above 80 psi | Portland: plumbing code requires a pressure-reducing valve; EPA suggests a PRV to hold about 60 psi |
1 psi is about 6.9 kPa, so 45–60 psi is roughly 310–415 kPa.
Old pipes and hard water
Denver Water notes that mineral deposits build up on the inside of lead and galvanized service line pipes, which narrows them and reduces flow. If your home has old galvanized or lead pipes, see how to check for lead pipes. To see how hard your water is, which drives scale in aerators and showerheads, find your town on the water hardness map.
Frequently asked questions
What is normal water pressure for a house?
EPA WaterSense says water pressure works best between 45 and 60 psi. Portland Water Bureau says it keeps most homes between 40 and 80 psi.
Why is my water pressure low in only one faucet or shower?
If only one fixture is weak, the problem is usually at that fixture: a clogged aerator screen or a showerhead with scale buildup. Clean or replace it before looking further.
Why is my water pressure low in the whole house?
Check that every valve, including the main shutoff, is fully open, and that a pressure-reducing valve or whole-house filter is working. Leaks and work on the water main can also lower pressure; your utility can tell you about outages.
How do I test my water pressure?
Buy a pressure gauge that screws onto an outdoor hose faucet (hose bibb). Turn off all other water in the house, open the faucet fully and read the gauge.